Descargar Imprimir esta página

Monogram ZKW36V Instrucciones De Instalación página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

36" STANDARD INSTALLATION
CASE TRIM INSTALLATION
Install the trim kit
side rails to the
exposed right and
left case walls
using the provided
#8 Phillips head
screws -
8
screws
per side.
Loosen top cover
hex head screws,
so you can slide
the top trim slots
between the hex
head screws and
the top cover.
TOE KICK INSTALLATION
Create a custom toe kick or use the 36" stainless steel toe kick provided.
For custom toe kicks, adhere magnet to the back side of the toe kick. The magnet can
be found in the box of parts that was taped to the side of the unit. The surface of the
toe kick where the magnet is to be placed must be clean and free of foreign material.
Center magnet vertically and horizontally.
Position toe kick on bottom portion of the front access cover.
72" STANDARD INSTALLATION
STANDARD INSTALLATION SPACE
NOTE:
ZKMV Heater Unification Kit needed
when pairing multiple units together.
ZKMV kit to be installed prior to installing
trims onto units.
Installation Instructions
Fit the top trim and side trim rails together by sliding
the exposed edges of the corner trim into the right and
left trim kit side rails. Align and drive the two number
8-32 Phillips head screws
side rails to ensure the top trim is snugly fit to the side
rails.
Tighten the top cover hex head screws, so the top trim
is secured to the cabinet.
4
into the screw bosses in the
31-1000725 Rev. 2

Publicidad

loading

Este manual también es adecuado para:

Zkw72v