Monitor Settings; Using The Videophone; Responding To A Visitor - SOMFY io homecontrol VSYSTEMPRO Manual De Uso

EN
Brightness
11
wheel
16 Contrast setting potentiometer
17 Colour setting potentiometer
12 Buzzer level selector
Conversation volume setting
13
thumb-wheel
Note: do not alter the setting of the potentiometer to the le of potentiometer 16 (factory setting).
When a visitor presses the call button on the external module, the monitor rings 4 times and the image of the visitor is
displayed on the monitor(s) depending on the configuration of the installation.

7.1 Responding to a visitor

[1]. Press button
activated .
[2]. You can communicate with your visitor.
Note: you can communicate with your visitor for a maximum of 1 or 2 minutes depending on the configuration of the external
module.
[3]. Press the button
module is
8

6 MONITOR SETTINGS

setting thumb-
Perform a communication test with the external module. Turn thumb-wheel
11 and potentiometers 16 and 17 until the image is displayed correctly.
Perform a buzzer test, adjust the 3-position selector to the position that
suits you.
Perform a communication test with the external module. Turn the thumb-
wheel until the voice of the person speaking can be heard clearly.

7 USING THE VIDEOPHONE

, the LED located behind the pictogram lights up and communication with the external module is
again, the LED located behind the pictogram goes out and communication with the external
terminated.
16
17
11
12
13
Copyright © 2016 Somfy SAS. All rights reserved.