Hama EWS-152 Instrucciones De Uso página 10

5. Installation
Note – Installation
• We recommend initially placing the base and measuring stations in the intended locations
without installing them and making all the settings described in 6. Operating – to do
• Only install the stations once the appropriate settings have been made and a stable wireless
connection is established between the stations.
• Do not mount the product above locations where persons might linger.
Note
• The wireless transmission range between the measuring and base stations is up to 30 m in
open spaces.
• Before installation, ensure that wireless transmission will not be disrupted by interference or
obstacles like buildings, trees, vehicles, high-voltage lines, etc.
• Before the nal installation, ensure that there is su cient reception between the intended
installation locations.
• When installing the measuring station, ensure that it is protected from direct sunlight and rain.
• The international standard height for measuring air temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage the product.
• Before installation, ensure that the chosen wall is suitable for the weight to be installation,
and make sure that there are no electrical wires, water, gas or other lines at the installation
site on the wall.
5.1 Base station
• Use the base to position the base station on a level surface.
5.2 Measuring station
• You can also position the measuring station on a level outdoor surface.
• We recommend installing the measuring station securely on an outdoor wall using the opening
(12). Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang up the base/measuring station using the opening intended for this purpose.
6. Operation
Note –
Input
Hold down the
6.1 Connection to the measuring station
• After you insert the batteries, the base station automatically searches for a connection to the
measuring station and performs initial setup.
9
button (7) or the button (9) to select values faster.