Satco Nuvo 67-132 Guía Rápida página 2

INSTALLATION: Wall Mounting
1. Remove side screw using screwdriver and open front
cover (Figure 1).
2. Determine appropriate mounting holes will be used,
and knock out cable entry hole on the back plate of the
housing.
3. Feed AC supply leads through the center hole into the
housing, Mount fixture to the Junction Box using the
(2) 1" 8-32 screws (Figure 2).
4. Make proper electrical connections, refer to Wiring
Diagram on page 1.
5. Push excess wire into Junction Box.
6. Connect Battery connector to PC board (Figure 3).
7. Restore Face plate with screws.
8. Adjust the lamp heads direction as per needs.
9. Restore AC power, charge indicator will turn on, press
test button for manual test.
Figure 2
Figure 1
Figure 3
2