Publicidad
Idiomas disponibles
Idiomas disponibles
Figure O
6. Remove any dirt and grass from the spool and housing.
7. Unfasten the end of the cutting line and guide the line
into the eyelet
figure P.
21
Figure P
8. Take the new spool and push it onto the boss
the housing. Rotate the spool slightly until it is seated.
The line should protrude approximately 5-3/8 inches
(136mm) from the housing.
9. Align the tabs on the spool cap with the slots
housing (figure Q).
10. Push the cap onto the housing until it snaps securely
into place.
Figure Q
CAUTION:
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
nOTE: Other replacement parts (guards, spool caps, etc.)
are available through BLACK+DECKER service centers. To
find your local service location call: 1-800-544-6986 or visit
www.blackanddecker.com.
WARNING:
recommended by BLACK+DECKER for use with this
appliance could be hazardous.
Rewinding spool from bulk line (use only
.065 in. round diameter line)
Do not use square, star or other shaped line or larger diameter.
These may cause feeding issues or overload the motor.
Bulk line is also available for purchase from your local retailer.
20
22
21
22
23
23
To avoid appliance damage, if
The use of any accessory not
nOTE: Hand wound spools from bulk line are likely to
become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
are recommended.
To install bulk line, follow the steps below:
1. Unplug trimmer.
2. Remove the empty spool from the trimmer as described
in "rEPlaCing ThE sPOOl".
3. Remove any remaining cutting line from the spool.
4. Make a fold at the end of the cutting line at about 3/4
inch (19mm)
line anchoring slots
Figure R
in
5. Insert the 3/4 inch (19mm) end of the bulk line into the
hole
26
in the spool adjacent to the slot as shown in
figure S. Make sure the line is pulled tight against the
spool as shown in figure S.
in the
Figure S
6. Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross (figure T).
7. When the wound cutting line reaches the recesses
cut the line. (figure S).
8. Fit the spool onto the trimmer as described in
"rEPlaCing ThE sPOOl".
CAUTION:
use the appropriate type of cutting line.
Figure T
. Feed the cutting line into one of the
24
as shown in figure R.
25
24
25
27
Before you begin trimming, only
English
26
27
,
7
Publicidad
