Troy-Bilt 030248 Manual Del Propietário página 6

ASSEMBLY
Your generator reqores some assembHy and is ready for
use after it has been properHy serviced with the
recommended o[Hand fuel
ff you have any quesqons with the assembHyof your
generator, pHeasecaHH t he generator heHpH[ne a t
1-888-6 m1-6708. If caHH[ng f or ass[stance_pHeasehave the
model revision_ and seriaHnumber from the data tag available.
See "KnowYour Generator" for data tag Hocation.
Remove Generator From Carton
H. Set the carton on a rigid fiat surface.
2. Remove everything from carton except generator.
3. Open carton compHeteHyby cutting each corner from
top to bottom.
4. Leave generator on carton to instaHH wheeH kit.
Install Wheel
Kit
NOT_:: VVheeH kitisnot intendedforoverothe-road use.
You will[ need the foHHowing tooHsto install[ these
components:
° [/2" or [3mm wrench
o Socket wrench with a [/2" or [3mm socket
o PHiers
Refer to Figure [ and instaJJ the wheeJ J(it as foJJows:
H. TIp generator so that engine end is up.
2. SHide axHe through both mounting brad<ets.
3. PHace a wheeH on each side as shown in Figure HA.
4. PHace a washer on axHe and then pHace an e-ring in axHe
groove.
5. [nstaHH e-ring with pHiers, squeezing from top of e-ring
to bottom of axHe.
Axle
Wheel
FHatV_/asher
Support Leg--'J-
Cap Screw Axle /
/
/ /
WheeH E-Ring
- Hex Nut
0