Elinchrom Transmitter Pro Manual De Funcionamiento página 18

User Manual
LIMITED DISTANCE RANGE:
EN
INTERFERENCE WITH OTHER 2.4 GHZ
NETWORKS, UNRELIABLE TRIGGERING:
AUTOMATIC HI-SYNC / HSS MODE;
SYNC UP TO 1/8000S:
SCANNING EL-UNITS:
NO EL-UNIT FOUND, OR SOME UNITS ARE
MISSING.
18
• Reposition the units.
• Increase the distance from walls and ceilings.
• ELSP Mode: In speed sync mode the distance
range is reduced by approximately 50 %,
switch back to normal sync mode.
• Outdoors, the distance range could be reduced
due to humidity, interference, obstacles etc.
• Try another frequency channel for both
transmitter and the receiver of the EL-unit.
• Reduce the distance between the flash unit and
Transmitter Pro.
• Elinchrom Action (previously A) heads are not
optimised for the Hi-Sync / HSS. To benefit
from better performance please use flash units
with Hi Sync or flash tubes heads.
• ODS fine tuning helps to optimise Hi-Sync
performance.
• If there is visible banding please reduce the
shutter speed on your camera, or set ODS and
adjust to minimise or avoid banding.
• Hi Sync / HSS functionality only works with
compaible cameras and the appropriate
Transmitter Pro and when the camera is set to
shutter speeds above 1/250s.
• Switch on all enabled EL-units, than switch
on the EL-Skyport Transmitter Pro on or go to
setup and rescan.
• Frequency, group and ELSP mode settings
must match with the Transmitter Pro.
• Ensure that all Skyport enabled units are
operating on the latest firmware.