Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-CP-D-SQ-(S3L, S6L, S9L)-SCCT Series
MOUNTING USING 1/2" PLUG
1.
Remove the four screws attaching the lens diffuser to the housing
and set the screws and lens aside.
2.
Unscrew the (4) screws attaching the LED mounting plate/reflector
to the housing. See Figure 1. Pry open the LED mounting plate/
reflector using a screwdriver in the opening slots on the sides of
the LED mounting plate/reflector. See Figure 2.
3.
Disconnect the two halves of the quick disconnect connector
attaching the driver to the LED mounting plate/reflector. Set LED
mounting plate/reflector aside for later use.
4.
Remove 1/2" plug from the side of the fixture that the conduit will
be fed from. Attach 1/2" conduit to chosen opening. Teflon tape
should be used on conduit threads to prevent water entry.
5.
Fixture is best mounted by drilling through (4) drill point locations
in corners of the housing. See Figure 3. Secure housing to
mounting surface using customer supplied hardware appropriate
for mounting surface.
NOTE: For wet locations, high grade caulking material, such
as silicone rubber, should be used between back gasket and
mounting surface and at all screw locations to ensure a watertight
enclosure.
6.
Complete the wiring to the incoming power per the Electrical
Connections section.
7.
Select the desired CCT and wattage using the switches on the
back wall of the housing. See Figure 4.
NOTE: Factory settings are 100% wattage and 4000K.
8.
Reconnect the two halves of the quick disconnect connector that
were disconnected in STEP 3.
IMPORTANT: Do NOT allow the LED mounting plate/reflector
to hang from the wires connecting the plate to the driver after
connecting.
9.
Position LED mounting plate/reflector on housing and secure by
retightening the (4) screws in the corners.
NOTE: Make sure no wires are pinched when attaching plate.
10. Remove the protective cover over the LEDs and discard. See
Figure 5.
NOTE: Do NOT touch the LEDs or the wiring coming from the
circuit board during the installation process.
11. Replace the lens diffuser on housing and tighten the screws in
the (4) corners. Gradually tighten lens screws in an "X" pattern to
prevent lens damage.
NOTE: Do not overtighten lens screws to prevent damage to lens.
http://lighting.cree.com/warranty
Document:
LPN00473X0001A3_A
Created By:
TMT
FIGURE 2
5.用一字螺絲刀撬開導熱板
FIGURE 3
(4) Drill Points
Locations
FIGURE 4
FIGURE 5
Protective Cover
Over LEDs
14.直接扯開L ED保護蓋
|
1-800-236-6800
Date:
5-20-2023
Publicidad
