Publicidad
Idiomas disponibles
Idiomas disponibles
Observe the safety instructions and warnings in this documentation and on the product.
5.1
Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 19
5.2
Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3
Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4
Installing holder for power tool
CAUTION
Hazard due to blocked air vents. If air vents are blocked the power tool can overheat, which can lead to
burn injuries and damage to the power tool.
▶ Never block the air vents of the power tool.
Hilti offers different holders for the power tools to be attached. Use the holder that corresponds to the shape
of the power tool.
Read the operating instructions for the holder!
1. Wrap the black tape round the black grip of the power tool.
▶ If necessary, use the spacer to keep the control switch of the power tool from being blocked.
2. Hook the belt hook into the loop of the holder and pull the belt tight.
3. Then wrap the loose end of the belt round the tightened length of the belt so that the end of the belt does
not get in the way when work is in progress.
4. Wrap the red belt round the red motor housing of the power tool.
5. Hook the belt hook into the loop of the holder and pull the belt tight.
6. Then wrap the loose end of the belt round the tightened length of the belt so that the end of the belt does
not get in the way or snag in the power tool when work is in progress.
5.5
Extending boom
WARNING
Risk of injury when extending/retracting the boom. Risk of trapping the fingers when the boom is moved
or when the cable is reeled all the way in.
▶ Wear protective gloves while extending/retracting the boom.
▶ Switch the product off before extending/retracting the boom.
▶ Detach the attached power tool and/or the power-tool holder before extending or retracting the boom.
▶ Make sure there is enough space around you before you extend or retract the boom.
22
English
2
2375781
*2375781*
Publicidad
