GENERAL INFORMATION
•
The appliance incorporates a flame effect, which can be used with or without heating, so that the comforting effect
may be enjoyed at any time of year. Using the flame effect on its own only requires little electricity.
•
The appliance is designed to be built into a surround, wall or structure.
•
This appliance requires regular cleaning and maintenance. Please refer to the Maintenance section for details.
•
Unpack the appliance carefully and retain the packaging for possible future use.
•
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound
which is related to the operation of the flame effect. This is normal and should not be a cause for concern.
•
This appliance must be installed on a horizontal and stable surface. Once installed, never move this appliance or lay
on its back, without draining the water from sump and water tank.
•
This appliance uses sound (beeps) and lighting (LED blinks) to advise you of errors. Please see troubleshooting
guide for further advice.
WATER QUALITY & CLEANING
This product contains and utilises water as an aspect of its operation. The adherence to the cleaning requirement as
detailed within the instructions is necessary to ensure that risk/s through bacterial proliferation are minimised.
All internal components of Optimyst that are in contact with water, feature antimicrobial technology, that inhibits the
growth of a wide range of bacteria by up to 99.99%. The product protection is effective for the useful lifetime of the
product. Its performance has been independently tested to ISO 22196 standard.
•
Normal clean tap water should be used in this appliance.
•
In areas with hard water, a water softener (decalcifier) is recommended and more frequent cleaning and mainte-
nance may be required.
•
Unfiltered water supplied from a well or any other unmonitored supply is not recommended.
•
Do not drink the water from the sump or from the water tank(s).
•
The water tank, sump, sump lid, tank cap and air filters must be cleaned once every week, particularly in hard
water areas. This is to remove dirt and prevent build up of limescale which could damage the product.
•
Ensure any soap/cleaning detergents if used are rinsed off fully to remove any residue before reusing parts. Do
not use any harsh or corrosive chemicals for cleaning as these could damage the parts.
•
If you intend not using the appliance for longer than a week, drain the water from sump and water tank and dry
the sump.
Technical Information,
Heat Output
Nominal Heat Output
Minimum Heat Output
Maximum Continuous Heat Output
Auxiliary Electricity Consumption
In Standby Mode
Electronic room temperature control plus week timer
Model No: 3-STEP-RGB
230V
P
1.16
Nom
P
1.16
min
P
1.16
max
-
-
P
0.21
Nom
4
240V
1.26
kW
1.26
kW
1.26
kW
-
-
0.22
W