Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION: Surface Ceiling and Wall Mounting
1. Attach crossbar to Junction Box (TM8*32–1).
2. Use screwdriver to open front cover to connect
battery connector.
3. Feed AC supply wires through canopy center hole.
4. Assemble canopy onto main body assembly with
(2) PM4*12 screws (supplied) and make proper wire
connections (see Wiring Diagram on page 1).
5. Use (2) PM4*40 screws (supplied) tighten canopy to
crossbar.
INSTALLATION: Surface Side Mounting
1. Attach crossbar to Junction Box (TM8*32–1).
2. Use screwdriver to open front cover to connect
battery connector.
3. Remove the hole plug from mounting end cap.
4. Pull out all AC supply wires and feed wires through the
center holes of mounting end cap and then canopy.
5. Once connections are made, refer to steps 4–8 from
Surface Ceiling and Wall Mounting.
6. Peel off protection film from EXIT panel, insert EXIT
panel into main body assembly gently.
NOTE: If EXIT panel is for single face, make sure EXIT
letter direction is correct.
7. Determine direction for chevron indicator (see
Determine Direction on page 1).
8. Ceiling Mount: the EXIT panel may be rotated
0° to 180°.
Wall Mount: the EXIT panel may be rotated 90°.
2
Publicidad
