Raid Setup Procedure (Sata Hdds/Ssds) - ONE K73-8X Guia Del Usuario

RAID Setup Procedure (SATA HDDs/
SSDs)
1. Start-up your notebook computer and press F2 to enter the
BIOS.
2. Go to the Boot menu, select UEFI Setting and press Enter.
3. Set UEFI Boot to "Enabled".
4. Press Esc to exit the menu and go to the Advanced menu.
5. Select SATA Mode, press Enter and select "Intel RST
Premium...".
6. Press F4 and <Yes> to "Save Changes and Reset".
7. After the computer restarts press F2 to enter the BIOS again.
8. Go to Intel(R) Rapid Storage Technology (in the Advanced
menu) and press Enter.
9. Select Create RAID Volume and press Enter.
10. You can now setup your RAID volume using any two installed
disks.
11. Go to Name: and press Enter.
12. Type a name of your choice for your RAID volume and press
Enter.
Figure 3 - Name the RAID Volume (Advanced > Intel(R)
Rapid Storage Technology)
13. Go to RAID Level: and press Enter.
14. Choose the RAID Level required (see
press Enter.
• RAID 0 (Stripe)
• RAID 1 (Mirror)
15. Go to any of the disks listed under Select Disks: and select a
disk name and press Enter.
8
16. Move the cursor down (use the arrow keys) onto X (or select the
17. You should select two identical disks to form your RAID volume.
18. If you have selected RAID 0 (Stripe) then you can adjust the
19. Go to Create Volume and press Enter.
20. The RAID volume will then be created and the RAID information
21. Press Esc to exit the menu.
22. Press F4 and <Yes> to "Save Changes and Reset", however
23. Click Next > Install Now to continue installing the operating
Table 1 on page 7) and
24. Follow the on-screen instructions to install the Windows 10
25. Install the Windows drivers (see
disk required) and press Enter.
Figure 4 - Select Disks
"Strip Size" to your requirements (It is recommended that you
set the "Strip Size" to 128KB).
will be displayed under Intel(R) Rapid Storage Technology (in
the Advanced menu).
ensure that the condition in the bulleted point below is met
before doing so.
• Make sure the Windows 10 OS DVD is in the attached DVD
drive, as the computer starts up it will automatically boot from
the Windows 10 OS DVD (you will be prompted to press a key
to boot from the DVD).
system as normal (see your Windows documentation if you need
help on installing the Windows OS).
operating system.
the Intel® Rapid Storage Technology (IRST) driver.
page 32). Make sure you install