Schou 100009 Manual De Instrucciones página 21

USE
Find yourself a suitable seated position. It
is not recommended to use the massage
gun when standing or when prone.
Choose a suitable massage head and plug
it into the massage gun by gently pressing
to secure it. To remove a head, gently
pull to remove. Do not add or remove
massaging heads whilst the massage gun
is ON.
Speed setting Beats per minute
1 2400
2 2600
3 2800
4 2900
5 3000
6 3200
To turn the massage gun ON/OFF press
the Power (Mode) button.
Start at the lowest power setting and
gently apply the massage gun to your
body to start your massage.
Short press the Power (Mode) button to
cycle through the available 6 power levels
(where 1 is the gentlest and 6 is the most
vigorous). Choose a power level where
you feel comfortable. Excessive pressure
can cause injury and may damage the
device.
Note:
The massage gun will automatically
turn off after 15 minutes. This is the
recommended massage time. Exceeding
the recommended massage time may
cause injury and/or damage to the
massage gun.
If the massage gun is on and you press
the massage head too hard, the massage
gun will stop working and "Er" will show
on the display. Please do not worry, this is
a built-in feature to avoid damaging the
motor.
HOW TO USE HOT-HEAD ATTACHMENT
Ensure that the massage gun is turned
OFF before attaching the Heating Head to
the massage gun.
Turn the massage gun ON by long
pressing the Power (Mode) button.
Long press the Heat (Mode) button for 2
seconds. The Heating mode symbol will
illuminate.
Place the massage gun on a suitable flat,
dry, heat resistant surface and allow 3-4
minutes for the Heating Head to reach
the appropriate temperature.
Press the Power (Mode) button to set the
appropriate power level.
Apply the massage gun to your body to
start your massage.
Note: Exercise caution to avoid body
parts which are sensitive to heat to
prevent burns.
When finished, hold the Power (Mode)
button to turn off the massage gun. Place
onto a suitable flat, dry heat resistant
surface and allow to cool fully before
adding or removing any accessories or
recharging.
HOW TO USE COLD HEAD
ATTACHMENT
Before using the Cold Head attachment,
detach it from the massage gun if
nessecary and place the head into a
refrigerator for around 2 hours. Do not
cool below 4°C.
Attach the Cold Head to the massage
gun.
Turn the massage gun ON by long
pressing the Power (Mode ) button.
Start on the lowest power setting and
slowly cycle through the power levels to
find your comfort level.
Apply the massage gun to your body to
start your massage.
Note: Exercise caution to avoid body
parts which are sensitive to cold.
When finished, hold down the Power
(Mode) button to turn the massage gun
off.
21
GB