Eldom SD210B Manual De Instrucciones página 9

EN
INSTRUCTION MANUAL
SONIC TOOTHBRUSH SD210
GENERAL INFORMATION
1. Spindle
2. Housing
3. Power switch
4. Vibration indicator
5. Multifunction button
6. Operating mode indicator
7. Brush head replacement indicator
8. Empty battery indicator
9. Replaceable head
10. Charging station (USB)
11. Case
INTENDED USE
The SD210 toothbrush has been designed to use sonic technology. During operation, the
toothbrush head vibrates at speeds ranging from 32,000 to as many as 42,000 beats per minute,
dynamically cleaning teeth and inter-dental spaces. This makes it possible to remove impurities
from hard-to-reach areas more accurately.
CHARGING THE DEVICE
The device may only be used after it has been charged.
Switch off the device before placing it on the charging station (10).
• Connect the charging station (10) to the power supply unit (not included) with the
parameters provided above, and then to the mains.
• Place the device on the charging station (10).
• When charging, the light (8) will be on and will go off when the device is charged.
• The device cannot be used while charging.
• The toothbrush will switch off automatically after placing it on the charging station.
REPLACING THE HEAD (9)
• The brush head (9) is a working part and should be replaced every 3 months for hygienic
reasons and whenever its bristles are worn. It is not subject to warranty repair.
• Each time the toothbrush has been used for 180 times, the indicator (7) will flash for
approximately 30 seconds to remind the user to replace the brush head (9). The brush head
(9) can only be replaced by the original brush head type included in the SDK200 range.
• The head can only be replaced when the toothbrush is switched off.
• Replacing the head (9) while the toothbrush is running may cause damage to the spindle (1).
• Attach the head (9) as shown in Fig. 1.
• Keep a small gap between the housing (2) and the head (9) to allow proper device operation Fig. 1.
If there is no gap, the device will be damaged when turned on.
OPERATING MODE SELECTION
• To select the operating mode, press the button (5) until the corresponding light (6) comes on
before switching on the toothbrush.
• You cannot change the mode while the appliance is running.
• To switch on the appliance, press the button (3).
• Once the appliance is switched on, the vibration intensity can be selected using the button (5).
• To switch the device off, press the button (3).
• The toothbrush will always start with the last selected mode and intensity level.
TECHNICAL DATA
Speed: 32,000 - 42,000 bpm
Battery: DC 3.7V, 700mAh, Li-Ion
Charging time: 8 hours
Operating time: up to 21 days (2 minutes
twice/day)
Toothbrush water-tightness: IPX7
Material
- housing: ABS/TPE
- head bristles: Dupont Nylon
Charging method: induction
Connect the station (10) to a power supply
unit with the following parameters: DC 5V,
2A (not included)
9