Descargar Imprimir esta página

Mercatus Y4 Manual De Instrucciones página 12

Abatidores y congeladores

Publicidad

TIME
0 °C
FREEZE
SOFT
+
PROBE
-35 °C
HARD
+
PROBE
0 °C
SOFT
+
TIME
-35 °C
HARD
+
TIME
How to launch a cycle
1. When no cycle is running, when in conservation phase. Conservation algorithm continues to work
normally up to the exit from stage 5.
2. Press "new" button for 1 second to start the selection phase of STANDARD cycles.
3. Display: the last cycle completed; there are 3 small "o" lightening on the display.
Example: CHILL + HARD + END_BY_TIME:
4. 1. This cycle can be launched immediately
4.2. Selection phase of STANDARD cycles:
3 couples of choices are available:
- CHILL or FREEZE
- SOFT or HARD
- End by TEMPERATURE or by TIME
Each single choice is displayed by the relative small "o":
- CHILL [upper "o" on the left] or FREEZE [lower "o" on the left]
- SOFT [upper "o" in the center] or HARD [lower "o" in the center]
- END_BY_TEMPERATURE [upper "o" on the right] or END_BY_ TIME[lower "o" in the right]
All the 3 couples of choices are available during the selection phase, e.g. when "soft" or "hard" has been
selected, the operator can come back to reselect "chill" or "freeze".
End By Temperature KEY is enabled only if Product Probe is configured (/A3=3)
5. After the cycle is selected, push "start" button for 2 seconds and the cycle starts.
6. Cancel the selection during the selection phase:
6.1 If press "new" : come back to the last cycle completed
6.2 If any operation within 10 seconds : flashing
if flashing within 10 seconds, the selection phase is aborted.
MNS00058.00
TEC12/57
PRT
Manual de Instruções
3 °C
120min
-18 °C
240min
/
120min
/
240min
-35 °C
-18 °C
120min
no phase 2
-35 °C
/
120min
no phase 2
5.
3.
N.º MNS00058.00
YES
-20 °C
YES
-20 °C
YES
-20 °C
YES
-20 °C

Publicidad

loading

Este manual también es adecuado para:

Y5