Descargar Imprimir esta página

Hamilton Beach Brita Hub Manual página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

This appliance is intended for household use only.
Electrical Shock Hazard: Connect only to a circuit that
w WARNING
is protected by a ground-fault circuit-interrupter (GFCI). This appliance
is provided with a polarized plug (one wide blade) to reduce the risk
of electric shock. The plug fits only one way into a polarized outlet. Do
not defeat the safety purpose of the plug by modifying the plug in any
way or by using an adapter. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, have an electrician replace the
outlet.
The length of the power cord used on this appliance was selected to
reduce the hazards of becoming tangled in or tripping over a longer
Filter capacity: Approximately 120 gallons (454 liters)
Rated service flow: Up to 0.5 gal/min (1.8 L/min)
Wattage: 29 W
Pump pressure range: 15–70 PSI
The replacement filter model number is CT01.
See everything Brita filters. Scan the QR code
or visit brita.com/performance-data.
If this device is not maintained and operated as
specified in this manual, there is a risk of exposure
to contaminants. For more information, visit the
manufacturer's Internet Web site at brita.com or the
California State Water Resources Control Board's Internet Web site at
waterboards.ca.gov.
Water reservoir is for municipally treated tap water only. Do not use
with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
4
Other Consumer Safety Information
cord. If a longer cord is necessary, an approved extension cord may
be used. The electrical rating of the extension cord must be equal
to or greater than the rating of the appliance. A common 18-gauge
household extension cord is rated for 600 watts and this appliance uses
29 watts. Care must be taken to arrange the extension cord so that it
will not drape over the countertop or tabletop where it can be pulled on
by children or accidentally tripped over.
To avoid an electrical circuit overload, do not use another
high-wattage appliance on the same circuit with this appliance.
Technical Specifications
Water minimum temperature: 33°F (1°C)
Water maximum temperature: 90°F (32°C)
NOTE: Filter is not to be used with hot water.
Performance Data Sheet
The Brita Hub™ Filter (Model #CT01) has been certified
by IAPMO R&T against NSF/ANSI Standard 53 for the
reduction of contaminants in system models as specified
on the Performance Data Sheet.
The Brita Hub™ Filter (Model #CT01) has been certified by
WQA against NSF/ANSI Standards 42, 53, and 401 for the
reduction of contaminants in system models as specified
on the Performance Data Sheet.

Publicidad

loading