Super Ego SEGO-Lamp Manual página 10

Technical data
Category: Direct pressure butane
Type of gas: Butane
Cartridge: Butane 190 gr EN 417 - Type 200
Nominal power: 1,000 W
Consumption: 70 g/h
IMPORTANT!
1. Before you connect this lamp to a gas cartridge,
please read these instructions carefully to make
sure you know how to use it properly.
2. Keep these instructions handy so you can refer
to them if necessary.
3. This lamp works with SUPER-EGO BTP C200
PRO EN 417 - Type 200 cartridges, in compliance
with standard EN 417.
4. This lamp must only be used outdoors or in
well-ventilated indoor areas. Its use inside
vehicles, caravans, tents, boats etc. is not
permitted.
5. Keep the device out of reach of children.
6. Do not use the device if the seals are damaged
or worn.
7. Do not tamper with the device.
Warning
1. This lamp must only be used in well-ventilated
areas.
2. Do not tamper
manufacturer accepts no liability for any
problems arising from: Incorrect use of the
device
− Carelessness while using the device
− Insertion of incorrect components (gas
cartridge, spare parts, accessories).
3. Before you insert a gas cartridge, read the
instructions that come with it.
4. Always insert and remove gas cartridges
outdoors.
5. Keep the device out of reach of children.
6. Do not use the device if the washer is damaged
or in poor condition.
7. Do not use the device if it is damaged or not
working properly or if there is a gas leak.
8. In the event of a gas leak, position the device
10
with the device.
outdoors, away from open flames and any
other flammable source or material. To locate
the gas leak - outdoors - use soapy water.
Never use a naked flame.
9. To use the device properly and safely:
− Always stand the device in an upright
position on a horizontal surface. This will
not only ensure that you obtain the best
possible performance and a well-balanced
and safe flame but will also stop the flame
from coming out of the burner in an
uncontrolled manner.
− Do not shake the device before or during use.
10. Do not use the device near to any flammable
materials.
11. Make sure that the gas valve regulator is
completely closed before you insert or replace
a gas cartridge.
12. Only use your hand to move the device when
it is cold.
13. Do not pick up the handle when the device is
in operation.
WARNING!
Some parts can reach very high
temperatures. Keep the device out of
reach of children.
Instructions for use (pages 6 and 7
Remove the lamp from the packaging and place it on
a firm and stable horizontal surface.
1. Inserting or replacing a gas cartridge
The
a. Always replace cartridges outdoors, well
away from other people and any source of
ignition such as naked flames, pilot lights or
electrical fires.
b. Before you change a cartridge, make sure
that it is in fact empty - shake it to hear the
noise produced by the liquid.
c. Close the flame regulator carefully (figure 3).
d. Make sure that the pressure washer is in
a perfect state of repair. If it is deformed
in any way, follow the instructions in the
"Service" section.
e. Before you insert a new gas cartridge,
make sure that the one being replaced is
completely empty. Never change a cartridge
while the device is being used.
f. Before you connect a new cartridge to the
device, check that the seals are in good
ENGLISH