Uline S-25309 Manual De Instrucciones página 3

Air Vent Cap
Loosen
Storage Clip
Suction Tube
Figure 1
1. Insert suction tube (non-flexible) into the sending
container. (See Figure 1)
2. Insert discharge tube (flexible) into the receiving
container.
3. Tighten the air vent cap by turning clockwise to
close vent.
PAGE 3 OF 9
Tighten
Operation Bulb
Discharge
Tube
OPERATION
4. Squeeze operation bulb a few times to start siphon
action. (Automatic siphon action will continue as
long as fluid level in sending container is higher
than the level in the receiving container.)
5. Stop fluid flow by turning air vent cap
counterclockwise before receiving container is
full. Gently lift discharge tube slightly to allow any
remaining fluid to drain.
6. Remove suction tube from sending container.
Connect discharge tube to storage clip to prevent
dripping.
NOTE: For any questions about chemical
compatibility, contact your chemical supplier.
1-800-295-5510
uline.com
0323 IS-25309