Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
UNPACKING
This product requires assembly.
„ Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
„ If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
OPERATION
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
„ General ventilation of most household spaces
NOTICE:
This product is designed to be powered by either
a RIDGID 18V battery pack (DC mode) or by elec-
tric power (AC mode). Either power source can
be used by installing an approved battery pack or
power cord into the product as described in this
manual.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
INSTALLING THE FAN HEAD ONTO THE
FRAME
See Figure 1, page 9.
NOTE: Do not operate the fan or connect the power cord
or battery pack without first installing the fan head onto the
frame.
„ Align the upper tubes on the fan head with the lower
tubes on the frame as shown. The spring-loaded locking
pins should be aligned with the holes in the lower tube.
„ Push the fan head and frame together until the locking
pins click into place in the holes.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.
„ Turn the control knob to the OFF ( O ) position.
„ Insert the battery pack into the product as shown.
„ Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
„ Depress the latches to remove the battery pack.
WARNING:
Always remove battery pack or unplug extension
cord from your product when you are assembling
parts, making adjustments, cleaning, or when not
in use. Removing battery pack or unplugging ex-
tension cord will prevent accidental starting that
could cause serious personal injury.
NOTE: The battery pack should be recharged after approxi-
mately 5 hours of use to reduce the possibility of damage.
Repeated deep discharge of the battery may decrease stor-
age capacity and battery life.
6 - English
Publicidad
