Publicidad
Idiomas disponibles
Idiomas disponibles
The Charging
When using the charger you can charge your battery inside or outside of the ebike.
Requirements for charging within the ebike
The drive system must be turned off. Open the cap of the charge plug, which is located with the frame or close to the battery.
Requirements for charging outside the ebike
Charging outside the ebike is started by turning off the drive system.
Please wait until all LEDs turned off. Now you can take out the battery by opening the lock and taking out the battery and charge
it inside your apartment or garage in your presence.
Start of charging process with the original charger
1.
Connect the charger to the mains.
2. Make sure that none of the battery LEDs are lighting when it's not mounted in the eBike.
3.
Now plug in the charging connector of the charger to the battery.
4.
Charging process start. The LEDs of the battery corresponding to its current state of charge begins to flash.
5. If charging does not start immediately, please push the capacity indicator button of the battery and wait until LEDs
are lighting.
Naming of LEDs
LED 5
LED 4
LED 3
LED 2
LED 1
During charging, the capacity is indicated by lighting and flashing of the battery's LEDs as follows:
LED 1 flashing:
LED 1 lighting LED 2 flashing:
LED 1, 2 lighting LED 3 flashing:
LED 1, 2, 3 lighting LED 4 flashing:
LED 1, 2, 3, 4 lighting LED 5 flashing:
LED 1, 2, 3, 4, 5 lighting:
Break up of charging process
To complete the charging, unplug the charging plug of the battery or out of the charge plug of the frame. Pull the power plug of
the charger from the wall socket.
English
0 – 20 % charged capacity
21 – 40 % charged capacity
41 – 60 % charged capacity
61 – 80 % charged capacity
81 – 99 % charged capacity
100 % charged
7 / 9
7
Publicidad
