Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Leak Test
Before performing a leak test, be sure that no
sparks can occur and you are in a spacious
outdoor area. Connect the propane gas tank
to the regulator and turn the valve on the unit
to the 'OFF' position. Brush a soap and water
mixture on all connections. Turn the gas supply
on; if bubbles occur on any connection there
may be a leak. If you smell gas or a leak is
discovered turn the gas valve off, disconnect
propane gas tank and do not use the
appliance until the leak is repaired.
WARNING
Pumice stones/lava rocks/LavaGlass® could
pop up and strike somebody's face during the
process of lighting this unit; stand away from
the unit for the first 20 minutes after igniting.
Flame should be a yellow/blue color and
between 1-7.5 inches in height.
Wait 50 minutes after extinguishing flame prior
to placing a lid (if applicable) or protective
cover on heating item.
To Light
1 . A fter assembling the gas tank, push and turn
2 . T o adjust the flame, turn the control knob
To Extinguish
1 . P ush and turn the ignition control knob (C)
2 . D isconnect propane cylinder to close the
10
7.5
in.
in.
25
19.1
cm.
cm
If the burner does not ignite with the burner
1
1
in.
in.
control valve open, gas will continue to flow
2.5
2.5
cm.
out of the burner and could accidentally
cm
ignite causing injury or property damage.
10
the control knob (C) counter-clockwise,
then use a match or lighter to light the
firebowl. Keep holding down the control
knob for 15 seconds.
(C).
clockwise to the'OFF' position.
gas supply if not using for a period of time.
WARNING
Publicidad
