EINHELL FREELEXO LCD BT Serie Manual De Instrucciones Original página 47

Troubleshooting
Fault
The robot lawn mo-
wer comes to a stop
in the mowing area.
The robot lawn
mower cannot be
switched on:
The robot lawn
mower cannot move
into the charging
station.
The robot lawn mo-
wer stops or travels
out of control when
near perimeter is-
lands.
The robot lawn mo-
wer is very loud.
The robot lawn
mower stays in the
charging station.
The robot lawn mo-
wer keeps returning
to the charging
station
Anl_FREELEXO_LCD_BT_SPK13.indb 47 Anl_FREELEXO_LCD_BT_SPK13.indb 47
GB
Possible cause
- Battery voltage too low
- Fault in the power circuit or
the electronic components
- The charging station (19) is
not installed correctly.
- The perimeter wire (18) has
not been installed correctly
around the peri meter is-
lands.
- Damaged blades (10)
- A large amount of foreign
bodies adhere to the blades
(10)
- The robot lawn mower has
started too close to obstac-
les
- Damaged blade drive or
drive motor
- Other parts of the robot lawn
mower are damaged
- Incorrect work time settings
- The rechargeable battery is
empty
- The rain sensor has been
triggered
- The battery temperature is
high
- 47 -
Remedy
- Bring the robot lawn mower back to the
charging station (19) for charging.
- Switch on the main switch (7) (ON).
- Contact your customer service center.
- Make sure that the LED indicator (21) on
the charging station (19) is lit up green.
- Make sure that the perimeter wires (18)
are connected at the charging station (19)
and that the front perimeter wire (18) is
laid in the middle underneath the charging
station (19).
- Make sure that the charging station (19) is
positioned correctly.
- Adjust the position of the perimeter wire
(18).
- Make sure that the perimeter wire (18)
does not cross over itself
- - Replace the blades (10). The 3 blades
(10) must all be replaced together at the
same time.
- The operating effi ciency of the robot lawn
mower is dependent on the sharpness of
the blades (10). You should therefore en-
sure that the blades (10) are maintained in
good condition.
- Switch off the robot lawn mower safely
and wear work gloves while you clean the
blades (10) in order to avoid getting cut.
- Arrange for the motor to be repaired or
replaced by your customer service center.
- Check the work time settings.
- The robot lawn mower will begin and end
its work in accordance with the set time
window. Outside this time window the
robot lawn mower stays in the charging
station (19).
16.11.2023 10:09:21 16.11.2023 10:09:21