Publicidad
Idiomas disponibles
Idiomas disponibles
Leaking Instructions
TO PREVENT LEAKING: Whenever you have water being sprayed there is a chance for leaking at
any connection point. Use the included PTFE Teflon Tape at all connection points where leaking
may occur.
PTFE TAPE: Apply PTFE thread tape ("Plumber's tape") to the connecting points on your sprayer.
If you get a leak it can be due to high pressure, no worries, just use the enclosed teflon tape and
you will be all set! Applying PTFE tape liberally around the threaded connections can help
reduce leakage.
(1 roll is provided, but more tape or "plumber's putty" can be found at your local store or online.)
TIGHTEN CONNECTIONS: Leaking commonly occurs when the nozzle pieces have not been
fully tightened. Connections can come loose over time, so check your nozzle connections and
re-tighten before each use and whenever you switch out your nozzles.
HD3000 PetraFlow
Nozzles
Triple Head Blue
Nozzle
Different head focus nozzle
that will give you a nice
spread mist.
Red Cone Nozzle
Will give you a four-spray
pattern. Twist tight to make
a fine mist that can reach up
to 10-15 ft.
Orange Angle Flower
Top Nozzle
Nice angle bent nozzle that
will give you a four-spray
shot up to 10 ft and a mist
when tighten.
Single Yellow Head
Nozzle
Single head nozzle for a flat
fan spray.
Angled Black Nozzle
Will give you a fine mist
when tighten up and a single
stream that goes up to
15-20 ft when loosen.
Publicidad
