Perles Dragon 1000 Manual Original página 17

damaged or its service life will be shortened. Besides,
excessive overloading will not improve either the speed or
the quality of the work.
We recommend you not to overload the tool in order the
overload protection will not switch off the tool; this way you
will protect the tool and the tool's performance will be
higher as grinding/cutting discs will be less worn out. We
advise you to cool down the tool under no load for at
least one minute in case of several successive
limiting functions.
Speed preselection (DRAGON 1200, DRAGON 1600)
allows the adjustment of speed with button
Tool's power is low at low speed settings, which enables
only easy works. Besides, the overload protection
operates at low power due to motor protection at low
speed.
Setting the corresponding speed when working
with DRAGON 1200, DRAGON 1600
Material Use
Plastic finish grinding
Metal finish grinding
paint removal
rust removal
grinding
rough grinding
brushing
Stone cutting
Restarting Protection
The restarting protection feature prevents uncontrolled
start of the power tool after an interruption in the electrical
current.
To reactivate it, move the on / off switch
position and turn the power tool on again.
DESCRIPTION
Thread for positioning the side handle (2x)
Side handle
Spindle lock-off button
Switch
Protection guard for grinding
Flange
Flange nut
Grinding / cutting disc
Spanner
Half flexible grinding disc*
Wire brush*
Release lever
Speed control button
Standard equipment
Flange and nut
Protection guard for grinding
Side handle
Spanner
*The shown or marked accessories are not included in the
standard delivery contents.
, Figure .
Button pos.
1
1
2-3
3
4-6
6
3
6
to the off
5
Adequate accessories for cutting and grinding
Use only those accessories that correspond to the data in
the table below.
The allowed speed of the accessory must be equal or
higher than the maximum no load speed of the tool,
indicated in the table below.
Grinding
125 6
disc
Cutting
125 3
disc
Wire
65 30
brush
PREPARING THE TOOL FOR WORK
Always disconnect the plug from power
source before making any adjustments or
changing any accessory!
Mounting the auxiliary handle to the tool, Figure
Position the delivered side handle
.
manner of work)
Fitting the protection guard on the tool, Figure
The power tool has a protection guard
adjusted to your work in stages without using any
additional tools.
• Push the release lever
support and keep it in this position, then place the
guard on the neck of bearing housing in the position as
shown in Figure , and push it in the direction
the support and turn it into the corresponding position
for work.
• Release the release lever, which must prevent the
turning of the guard. Turn the guard a little bit more with
the lever released, if necessary, so that the lever will
clamp in the guard tooth and prevent its turning.
The released release lever must always prevent the
rotation of the guard.
The protective side of the guard must always face the
user.
Always check the fitting of the guard with the release
lever in the manner described under the chapter for
checking the fitting between the guard and the release
lever.
Guard's usage range, Figure
The guard can be adjusted to work in stages of 15° only in
its usage range that is marked in figure
uttermost positions of the guard are shown (
uttermost left position and
and the arrows indicate the allowed direction of turning.
The guard can be used only within this range, because
the release lever does not block its rotation outside this
en
22,2 11.500 80
22,2 11.500 80
M14 11.500 45
(according to the
, which can be
in the direction to the
to
, where both
–
– uttermost right position),
17