Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3.
Insert the hose (1), hot supply line (2), cold supply line
(3) and outlet hose (4) one by one vertical through the
hole of the top mount install (B). Carefully insert the
hoses into the base. Place the faucet assembly onto
the top mount install (B) as shown in the figure.
Note:
Make sure the four hoses are not crossed or
interlaced before sliding to the top mount install (B).
During the installation process, the three concave
points at the bottom of the faucet (A) need to be
aligned with the three convex points of the top mount
install (B). The faucet (A) should be tightly attached to
the deckplate to prevent loosening.
4.
Push the quick connector (C) firmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been made.
Open the weight (F) in the direction shown, install the
weight (F) at the point of the hose marking "weight
here".
5.
Installing the soap dispenser:
Insert the soap assembly (H) through the
selected hole in the sink. Secure the soap
assembly to the sink with the soap dispenser
quick install nut (I) provided. Push up the quick
install nut (I) to sink and hand-turn to tighten.
From under the sink, screw the soap bottle (J)
onto the soap assembly (H) shank. Insert the
soap pump (G) down into the soap assembly (H).
3
2
1
4
H F
5
Sink
Push
up
Screw
Sink
5
A
Sink
4
3
B
Sink
Push
H F
J
I
I
Back
Back
1
H C
G
H
H
I
J
K
Publicidad
