DEFA WorkshopCharger 125 A Manual Del Usuario página 4

•
Please read the manual carefully before use.
•
Inexperienced users, children aged 8 and above and persons with reduced physical or mental capabilities must only use this product under
supervision or after having read or been given instructions on safe use.
•
Do not attempt to charge non-rechargeable batteries.
•
Only charge lithium batteries with an integrated Battery Management System (BMS).
•
After use, disconnect the mains power before disconnecting from the battery.
•
Only use the charger in well-ventilated area and on vented batteries.
•
This charger must only be repaired by professionals.
•
Never intentionally connect the charger incorrectly, even though it is protected against short-circuiting and reverse polarity.
•
The charger does not draw current from the battery when the mains power is not connected.
•
Do not use the charger in a highly flammable environment.
•
Do not charge a damaged battery.
•
During charging, batteries may release highly explosive gasses. Take care not to have sparks, open flames, cigarettes or similar in the vicinity of the
battery and always ensure sufficient ventilation.
•
Battery acid is corrosive and harmful. It damages clothes, metal and varnish. In case of spillage and contact with skin, wash and rinse thoroughly
with water and consult a doctor.
•
Lead and other chemicals that are used in batteries are toxic. Wash skin and hands thoroughly after working with batteries.
DEFA WorkshopCharger is based on modern switch-mode technology. This charger represent the latest technology within battery charging and will give
the batteries optimal performance and durability. It is well suited to charge lead/acid, AGM, EFB, GEL and lithium-ion batteries up to approx. 600 Ah for
a unlimited time.
The charger can either be installed by fixing the bracket directly to a wall or be hung on a wall bracket. See C and D page 3 for drill patterns.
See figure B, page 2
1. Back button
2. Scroll Wheel
3. Power button
4. AC input connector
Read the user guide carefully. Please contact DEFA or a qualified person if you are unsure about how to safely use the charger.
Connect red clamp to positive battery terminal (+) and black clamp to (-) or the connection point recommended by the vehicle manufacturer. The charger
is intended for use with lead/acid, AGM, EFB, GEL and Lithium batteries. The battery manufacturer's recommendations for charging voltages shall always
be taken into consideration.
If the temperature sensor is connected, the charge voltage will be temperature compensated. Lithium charging programs do not include this function.
Connect the AC mains cable to the charger. Push the power button. The charger will start. To turn off the charger, push the power button again.
NOTE: To make sure the correct charging voltages are applied, the charging cables must not be shortened or made longer.
4
EN
SAFETY
ABOUT THE CHARGER
INSTALLATION
BUTTONS AND CONNECTORS
5. USB connector
6. Temperature sensor connector
7. Charging cables
8. Cover for charge cable screw terminals
USE