Publicidad
Idiomas disponibles
Idiomas disponibles
29
Children must be supervised to ensure that they
do not play with the device.
30
This heater must be placed on a horizontal level
floor.
31
If the power cord of this device is damaged, it
must be replaced by the manufacturer, their ser-
vice department or a similarly qualified person to
avoid dangers.
32
Do not use this heater with a programmer, timer
switch, separate remote control system or any
other device that automatically turns the heater
on, as there is a risk of fire if the heater is covered
or incorrectly positioned.
33
To avoid electric shock, do not immerse the de-
vice, cable or plug in water or other liquids.
m ATTENTION!
This power tool generates an electromagnetic field dur-
ing operation. This field can impair active or passive
medical implants under certain conditions. In order to
prevent the risk of serious or deadly injuries, we recom-
mend that persons with medical implants consult with
their physician and the manufacturer of the medical im-
plant prior to operating the machine.
5. Technical data
Voltage
Frequency
Power consumption (P)
Protection class
Protection category
Remote control
Battery
6. Before commissioning
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
20 | GB
m ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
• Check the device for transport damage. Immediate-
ly report any damage to the transport company that
delivered the device.
• Long supply cables (extension cable) should be
avoided.
• Do not operate the device in damp or wet areas.
7.
Assembly
m Attention!
Always make sure the device is fully assembled before
commissioning!
Before connecting the machine to the mains power,
make certain that the data on the type plate matches
with the mains power data.
m Warning!
Always pull out the mains plug before carrying out ad-
220-240V~
justments on the device.
50Hz
1800W
Installing the rollers and feet (Fig. 2)
1.
Fix the rollers (11) with 4 screws M4x10 (6) on the
I
underside of the base plate (5).
IP34
2.
Slide the foot sleeves (12) over the feet (13) and
Yes
screw them into the base plate (5)
AAA
Installing the brackets (Fig. 3)
1.
Fix the brackets (3) to the base plate (5) with the
hexagonal bolts M6x50 (9).
2.
Slide the cover base plate (4) over the two brackets (3).
Installation of the radiator (Fig. 4)
1.
Place the radiator (1) on the two brackets (3) and
secure it with 2 screws M4x10 (6).
2.
Guide the connection cable through the opening in
the base plate (5).
Installation of the fascia boards (Fig. 5/6)
1.
Slide the cover base plate (4) upwards and push
the fascia board (2) on both sides between the
brackets (3).
www.scheppach.com
Publicidad
