Connecting With Cleaner; Concerning Cutting Of Stainless Steel Plates; Selection Of Blades; Housing The Allen Wrench - Hitachi Koki CJ 14DL Manual De Instrucciones

CONNECTING WITH CLEANER

By connecting with cleaner (sold separately) through
dust collector (sold separately) and adapter (sold
separately), most of dust can be collected.
(1) Remove the allen wrench from the base.
(2) Move the base fully forward. (Fig. 15, 16)
(3) Attach the chip cover.
(4) Connect the dust collector with adapter. (Fig. 22)
(5) Connect the adapter with the nose of cleaner. (Fig.
22)
(6) Insert dust collector into the rear hole of the base
until the hook catches in the notch. (Fig. 23)
(7) Press the hook to remove the dust collector.
NOTE:
Wear the dust mask additionally, if available.
Chip
cover
Base
Dust
collector
Notch
Base
Rear
hole Dust
CONCERNING CUTTING OF STAINLESS
STEEL PLATES
CAUTION:
In order to prevent blade dislodging, damage or
excessive wear on the Plunger, please make sure to
have surface of the base plate attached to the work
piece while sawing.
Nose Cleaner
Adapter
Fig. 22
Hook
Nose
collector Adapter
Fig. 23
When cutting stainless steel plates, adjust the unit as
described below:
1. Adjust the speed
Blade Thickness of material
1/16" – 5/32"
No. 97
(1.5 – 2.5 mm)
NOTE:
The higher the speed is, the quicker the material is
cut. But the service life of the blade will be reduced
in this case. When the speed is too low, cutting
will take longer, although the service life will be
prolonged. Make adjustments as desired.
2. Set the orbital position to "0"
NOTE:
When cutting use cutting fluid (oil base cutting
fluid) to prolong the blade's service life.

SELECTION OF BLADES

Accessory blades
To ensure maximum operating efficiency and
results, it is very important to select the appropriate
blade best suited to the type and thickness of the
material to be cut. Three types of blades are
provided as standard accessories. The blade
number is engraved in the vicinity of the mounting
portion of each blade. Select appropriate blades
by referring to Table 4.

HOUSING THE ALLEN WRENCH

It is possible to house the allen wrench on the base.
(See Fig. 24)
Base
Fig. 24
English
Speed
Middle speed
Allen wrench
17