EINHELL TE-SV 18 Li Manual De Instrucciones página 8

3. Intended use
The equipment is suitable for dry vacuuming
when using the appropriate fi lter. The equipment
is designed only for home use and only for
domestic settings. The equipment is not suitable
for the vacuuming of combustible, explosive or
harmful substances.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or
industrial businesses or for equivalent purposes.
4. Technical data
Motor power supply: ............................ 18V
Tank volume: .................................. 0.16 Gallons
Weight (Tool only): ........................................4 lbs
Battery and charger
Please only use batteries and chargers from the
Power-X-Change series, e.g. 1.5 Ah and 6 Ah
batteries and charger model Power-X-Charger 3A.
5. Before starting the equipment
Warning!
Always pull out the battery before making
any adjustments to the equipment.
5.1 Assembling the equipment (Fig. 3-4)
Slot the equipment head (3) and the motor brush
(10) onto the suction tube (7) until they latch
in place with a click. The motor brush (10), the
crevice/brush nozzle (18) and the fl exible crevice
nozzle (19) can be mounted either directly on the
equipment head (3) or on the suction tube (7).
Warning! Make sure that nothing is jammed
between the equipment connections.
Anl_TE_SV_18_Li_USA_SPK7.indb 8 Anl_TE_SV_18_Li_USA_SPK7.indb 8
EN
5.2 Fitting the fi lters
Important!
Never use the equipment without fi lters!
Always make sure that the fi lters are securely
seated!
Fitting/removing the fi lters (Fig. 6-7)
Press the release button (16) and remove the
container (4). You can then take the fi lter (15)
together with the fi lter cage (14) out of the
container (Fig. 7). The fi lter must be taken out of
the fi lter cage for it to be thoroughly cleaned.
5.3 Fitting the wall holder (Fig. 5)
Danger! Check that there are no electric cables
or other installations (such as water pipes) near
the drill holes. Make sure that the wall holder is
fi rmly seated on the wall in a horizontal position.
Use only suitable fasteners on a wall capable of
bearing the load.
The supplied wall plugs and screws are suitable
for the following: concrete, densely structured
natural stone, solid bricks, solid limestone bricks,
solid lightweight concrete bricks, and aerated
concrete.
5.4 Fitting/removing the brush roller (Fig. 8)
While pressing the release button (11) push it to
the left and hold it tight. Lift the brush roller (12)
out of the housing. Assemble in reverse order.
Make sure that the brush roller latches in place
correctly.
5.5 Nozzles
Crevice nozzle (Fig. 2)
The fl exible crevice nozzle (19) is designed for
vacuuming in corners, edges and other areas that
are diffi cult to access.
Crevice/brush nozzle (Fig. 9)
The crevice/brush nozzle (18) can be used as
either a crevice nozzle or a brush. To use it as a
brush, press the button (23) on the side of the
nozzle and push the brush forward until it latches
in place.
- 8 -
02.06.2023 08:31:54 02.06.2023 08:31:54