geberit EFP 203 Manual página 26

EN
Pressing with Geberit
pressing attachments
WARNING
Risk of injury caused by flying
fragments
▶ Wear protective goggles and a
protective helmet.
WARNING
Risk of injury caused by the use
of incorrect pressing
attachments
▶ Only use pressing
attachments that correspond
to the diameter of the press-
fittings to be processed.
WARNING
Risk of fire from heat build-up
▶ Allow the pressing tool to cool
down for at least 30 minutes
after 30 minutes of continuous
operation.
▶ Do not place or store the hot
pressing tool near easily
flammable materials.
The pressing procedure can be
cancelled at any time. → See
"Cancelling the pressing procedure".
To improve ease of use, the pressing
head of the pressing tool can be
turned to any position up to 180°
before pressing. The pressing head
can only be rotated before the
pressing procedure.
Prerequisite
– Pipe ends are deburred and clean.
– The pipe section and pressfitting are
fitted together according to the
installation manual of the piping system.
– The pressing attachment is inserted
correctly.
26
1
Connect the pressing tool to the
power supply system.
✓ The tool is ready for operation.
2
Fit the pressing attachment to the
pressfitting correctly and do not tilt.
→ See user manual for the Geberit
pressing attachments in question.
CAUTION
Danger of crushing
▶ Keep hands away from the
pressing attachment.
3
Press the start button and keep it
held down until the pressing
operation is complete.
Result
✓ After the pressing operation has been
completed, the roller drive returns to its
starting position. The pressing tool is
once more ready for operation.
36028798914619019 © 08-2022
968.393.00.0(01)