Ego Power+ HPW2000E Manual página 10

EN
CONNECTING THE LANCE AND WAND
(Fig. E1 – Fig. E2)
To disconnect, screw the wand from the lance and then
pull it out; loosen the knob on the lance and then pull
back the outer ring of the quick-coupler of the gun to pull
out the lance.
WARNING:
Always hold the gun with one hand and
the lance with the other hand when disconnecting the
lance from the gun. Personal injury may result if the lance
falls.
CONNECTING A NOZZLE (Fig. F1 / Fig. F2)
NOTE:
The nozzles cannot be connected to the lance.
◾
Choose the 15° nozzle, 25° nozzle, 40° nozzle, or
Turbo nozzle to install onto the wand (Fig. F1).
F1-1 15° Nozzle
F1-3 40° Nozzle
◾
The rinse nozzle is connected to the gun directly
(Fig. F2).
F2-1 Rinse Nozzle
WARNING:
Always hold the gun with one hand and
the nozzle with the other hand when disconnecting the
nozzle from the gun. Personal injury may result if the
nozzle jumps out.
Use the table below to pick the right nozzle for the job.
Nozzle Selection
Yellow 15° Nozzle
Green 25° Nozzle
White 40° Nozzle
Gray Rinse Nozzle
Turbo Nozzle
10
56V LITHIUM-ION PRESSURE WASHER — HPW2000E
F1-2 25° Nozzle
F1-4 TURBO Nozzle
Applications
Clean small metal, concrete,
or wood surfaces.
Clean larger metal, concrete,
or wood surfaces.
Clean wide metal, concrete,
wood, or vinyl surfaces.
Rinse vehicles.
Rinse the detergent off of
metal, concrete, wood, or
vinyl.
Clean hard surfaces only. To
prevent surface damage, do
not use on cars and wooden
surfaces.
CONNECTING THE FOAM CANNON (Fig. G)
The foam cannon is connected to the gun directly.
To disconnect, pull back the outer ring of the quick-
coupler, and then pull out the foam cannon.
CONNECTING THE SIPHON HOSE (Fig. H1 – Fig. H2)
When using a water bucket (not provided) as a source of
water, connect the pressure washer to the siphon hose.
NOTE:
Prefill the bucket so when immersed filter does
not float to the surface.
CONNECTING TO A GARDEN HOSE (NOT PROVIDED)
When using water tap (not provided) as a source of
water, connect the pressure washer to a garden hose
(not provided).
OPERATION
APPLICATION
You may use this product for the purposes listed below:
◾
Cleaning dirt on automobiles, walls, floors, etc.
ATTACHING/DETACHING THE BATTERY PACK
Use only with EGO's battery packs and chargers listed in
Fig. A2.
Refer to corresponding battery packs and chargers
manuals for more details.
Fully charge before first use.
NOTE:
Using one battery pack will not allow you
achieve TURBO speed. For best performance, we
strongly recommend use of two 5.0Ah or greater Ah
battery packs.
1. Raise the battery compartment cover by lifting the
front of the cover.
2. To attach, align the battery ribs with the mounting
slots in one and press the battery pack down until
you hear a "click". Attach the other battery (Fig. I1).
3. To detach, depress the battery-release button and
pull the battery pack out (Fig. I2).
I2-1 Battery-release button
4. Close the battery compartment cover.