Costway EP24525DE Manual Del Usuario página 7

Warning: Do not pour the water into the internal water tank located
underneath the ice basket. This tank is not big enough and will
effect the ice making performance.
2. When you plug the unit, the power symbol<
Press the <ON/OFF>button, the unit will start making ice cube, ice
making symbol< > will keep running. The left up corner of display
area will show the ambient temp. After several mins, this area will
show flash number, the ice making will countdown,i.e:10M means
the ice making will finish 10 mins later.
3. When ice maker harvest, symbol<
from top water reservoir to bottom water tank through solenoid
valve,the symbol < > will be on ,when the water in the bottom
water tank is full, the symbol <
making cycle start again. When there is no water in the water
reservoir, the symbol <
water again, then restart the unit to make ice cube. Or fill water
directly and wait 20mins, the unit will restart.
Remark:The ice making cycle lasts about 13 to 25 minutes,
depending on the ambient temperature. And for the first time,
according to the initial water temperature, ice-making last time will
be a little longer. In the extreme hot room temperature, ice-making
time may be vary a lot, but it will not exceed 35 minutes.
If you think the ice cube is not thick enough, during ice making,
press the<+>and<->to set the ice making lead time. Press one time
and the ice making cycle will in crease or reduce one min, 6min
most.This can only start from the new cycle.
4. Press the button <time>more than 5s, the machine will enter
"CLEAN" model.
12
Cover for the water reservoir
> will flash.
> flash, the water will flow
> will be off, then the next ice
> will keep on. Turn off the unit and fill
5. When Ice Full symbol< >is on, the unit will stop, take out the ice
cube inside, the unit will start working again.
If press the button<ON/OFF>more than 5s, when the ice maker is
working, the unit will start harvest. Press button<ON/OFF>, the unit
will turn off.
Timer setting. When the machine is turned on, the timing function
sets the time to turn the machine off. When the machine is in the
standby state, the timing function sets the time for the machine to
start.
Press the<TIMER>button, the display will show<1H>, and then
press <+> and <-> to set the time. During the setting, the H is flash,
after 5s, the H will keep on and unit will in your timer setting.
6. Water Drain: take off water draining cap the bottom of unit, then
drain the water inside. It is better that exchange water every 24
hours and clean unit every 3 days.
Warning
A. Make sure the water tank, water filter and the water separator
pipe is not blocked, clean them
B. The water temp will effect the ice making capacity. The lower
temp, the more ice cube produce.
C. The cooler ambient temp, the more ice cube produce.
D. Always use good quality water to make sure the pump work well.
Bad quality water will cause pump noise, but doesn't effect the unit
working.
E. The compressor restart 3mins later if you turn off the unit.
13