Publicidad
Idiomas disponibles
Idiomas disponibles
ADR 71 ADR 94 ADR 97
Problem
The unit does not turn on
Too much time without working
Air comes out, but the
cooling/heating effect is not
good
Water leak when moving
The display does not turn on
when the device
There is no response when
pressing the function keys
Abnormal sound
There are water drops on the
surface.
TROUBLESHOOTING
Cause
The plug inserted properly.
Low battery in the remote control.
Please wait three minutes in case the system is protected.
You can lower the selected temperature, the previous one may be very
close to the ambient temperature.
The air exit is obstructed. Please eliminate the obstacle.
The door or windows are open. Aire outputs cause a poor room
insulation effect.
The filter is blocked. Please limit it.
The air outlet or entrance is blocked.
The established temperature is too high or too low.
Erroneous mode, incorrect temperature and air speed configuration.
Drain the water from the tank before moving the device.
Verify that the continuous drain plugs is well placed and in good
condition.
Bad contact between the plug and the power outlet or disconnection of
the power cable, without energy supply.
Check if the children's lock function is configured.
A few minutes before starting the machine, it is normal to feel a slight
vibration and an abnormal sound.
It is normal for air exit, panel and other parts to produce water drops
when they work under conditions of high environmental humidity.
If it works in open spaces for a long time in cold mode, water drops will
be generated. Please close the doors and windows.
An too low air speed can cause water droplets, increase speed.
"This phenomenon may also be due to an opening angle that is too
small from the frontal lams.
Open the lamps or configure it to automatically oscillate."
31
Publicidad
