Publicidad
Idiomas disponibles
Idiomas disponibles
2. USING THE Dust Collection BOX (SEE FIG E)
A) ATTACH THE DUST BOX
Your sander is equipped with a Dust Collection
Box (2), which is designed for collect
dust task. Insert the Dust Collection Box into the
rear dust outlet of sander. Then pull
the Dust Collection Box and make sure it is
tightened securely on the dust outlet.
B) EMPTY DUST BOX
For more efficient operation, empty dust box
every 5-10mins. This will permit the air to
flow through the box better.
To empty the dust box, pull off the dust box out
of the dust extraction outlet directly and shake
out dust.
E
3.USING THE DUST OUTLET (SEE FIG F)
Your sander is equipped with a 35mm dust outlet,
which are designed for connecting the
hose of a vacuum cleaner.
If the vacuum hose is 35mm, insert the hose
directly into the rear dust outlet of sander.
First please turn on the vacuum cleaner, and
then turn on the sander. If you stop sanding,
first turn off the sander, and then turn off your
vacuum cleaner.
NOTE: Please pull the dust adapter to make sure
tightened securely on the dust outlet.
When using your tool on plasterboard, please
USE the vacuum cleaner (sold
separately). It can increase collection efficiency,
and reduce airborne dust drastically. It
can also keep dust away from the working
environment.
F
4. OPERATING THE ON/OFF SWITCH (SEE
FIG G)
Slide the on/off switch to the position marked"I"
to start the tool.
Slide it to the position marked "0" to stop it.
G
5. USING THE SANDER
The workpiece to be sanded must be secured. If
it is small or it may move during
sanding, it must be held in a vice or suitably
clamped.
Be sure to hold the sander firmly whilst it is on
and apply it gently to the work, it may
"kick" on first contact. Hold the sander so that it is
flat on the work and move slowly,
preferably with a smooth, circular motion.
Regularly check the condition of the sanding
paper and replace when worn for best results.
6. FLUSH SANDING FACILITY
Your sander can sand flush on three sides of the
baseplate which allows easy access to
corners and edges of mouldings.
7 . ORBITAL SANDING
Your sander operates in small a circular rotation
which allows efficient material
removal. Operate your sander in long sweeping
movements across your workpiece and
even across the grain. For a finer finish, always
use a fine grain sanding paper and only
move the sander in the direction of the grit and
never across the grain. Do not allow
your sander to remain in the same position
otherwise you will remove material and
create an uneven surface.
8.SELECT THE RIGHT SAND PAPER
Selecting the correct grit of sandpaper is an
extremely important decision that will
allow you to achieve the best quality sanding
finish.
Coarse grit will remove the most material and
finer grit will give you the best finish in
31
Publicidad
