Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.
2. MACHINE INFORMATION
Intended use
This hot air gun is intended for a wide range
of applications including plastic welding, the
deformation of material, heat-shrink tubing,
removing material residues or drying paint. It is
also suitable for loosening of adhesive joints and
the defrosting of water lines.
Technical specifications
Model No.
Voltage
Frequency
Power input
Weight
IP Class
Position I
Air flow
Air temperature
Position II
Air flow
Air temperature
Position III
Air flow
Air temperature
Description
The numbers in the text refer to the diagrams on
page 2-3
Fig. A-C
1. Switch
2. Ventilation slots
3. Nozzle outlet
4. Fishtail nozzle
5. Glass protection nozzle
6. Flat rear side
. When using a cable
2
HAM1019
220-240 V~
50 Hz
2000 W
0.66 kg
IP 20
500 l/min
50 °C
250 l/min
400 °C
500 l/min
600 °C
3. OPERATION
The Hot air gun can be used for:
• Plumbing work like tube connections, solder,
bowing tubes;
• Removing paint, varnish and lacquer without
fire risk;
• Quickly drying of appliances which have
become wet;
• Drying surfaces for quick repairing;
• Removing self-adhesive labels in a clean way
placing PVC labels;
• Blistering after sticking PVC materials can be
smoothed after heating;
• Easy removing of vinyl carpeting:
• Forming all synthetics with a low temperature
(400 degrees) among which polyethylene and
PVC;
• Forming all synthetics with a high temperature
(600 degrees) among which acryl and
plexiglass;
• Smelting synthetics, among which matters and
foils with PVC layer;
• Applying heat shrinking tubes;
• Shrinkwrappers;
• Thawing tubes and engines;
• Repairing finishing layers: enamel of bath and
household appliances; applying epoxypowder
cover layers;
• Repairing of ski's, surf-boards and other
sports goods;
• Unscrewing too fast fixed screws and
connections.
Operation
Fig. A
You can work manually with this hot air gun or you
can put it in a vertical position.
• Check if the mains switch is on position '0'
before you connect the apparatus;
• Keep the main lead always away from the hot
air stream and the mouth piece;
• Put the mains switch in position "I", "II" or "III"
to let your hot air gun operate:
I = 50 degrees, air flow 500 l/min.
II = 400 degrees, air flow 250 l/min.
0 = Off
III = 600 degrees, air flow 500 l/min.
When the temperature is excess 600° C, the heats
switches it off automatically, however, the heater
5
Publicidad
