BH FITNESS H923E Manual De Instrucciones página 5

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES.
To fit the batteries, remove the rear
cover on the monitor, Fig.1, and
carefully insert the two "R-6" type
batteries into the battery compartment
(A) making sure that the battery's
polarity is correct
battery's «+» terminal with the «+»
sign inside the battery compartment,
and the «-» terminal with the «-» sign).
Close the cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important:
components in special containers Fig.2.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this monitor simultaneously
displays:
Speed; R.P.M.
Minute), Calories, Distance, Exercise
Time, Pulse rate (Optional).
The screen switches on automatically
as soon as you start exercising.
The monitor switches off automatically
if the unit stands idle for more than 45
seconds, resetting all the parameter
values back to zero.
uses two 1.5
(matching
Deposit electronic
(Revolutions
English
A. SPEED FUNCTION.-
volt This function displays the speed in
km/h.
B. RPM FUNCTION (Revolutions
Per Minute).-
This function displays the RPM of the
crank.
the
C.- TIME FUNCTION.-
This function counts up in steps of one
second to a maximum of 99:59
seconds.
D. TRIP FUNCTION.-
This function counts up in steps of
0.01 km/ml, up to a maximum of 99.99
km/ml.
E. CALORIE FUNCTION.-
This function counts up in steps of one
calorie, up to a maximum of 999.9
calories.
F.- TELEMETRIC PULSE RATE.-
To measure your pulse rate during
exercise you will need to wear the
chest band (OPTIONAL). Fig.3.
T R OUB L E S HOOT ING G UIDE .-
Problem: The display comes on but
Per
only the Time function works.
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a.- Check that the batteries are fitted
correctly.
5