Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
CAUTION! Keep this device away from rain and moisture! Unplug mains lead
before opening the housing!
The Q-P00712 is made of a new type of high temperature strength of engineering plastics and cast aluminum casing
with nice outlook. The fixture is designed and manufactured strictly following CE standards, complying with
international standard DMX512 protocol. This manual covers the important information on installation and applications.
Meanwhile, please keep this manual well for future needs.
• Be sure to read the USER MANUAL carefully before using this product.
• Be sure to keep the USER MANUAL properly for future needs.
• Use this product correctly when you can fully understand the User Manual
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in this manual.
IMPORTANT
• The manufacturer will not accept liability for any resulting damages caused by the non-observance
of this manual or any unauthorized modi cation to the device.
• Please consider that damages caused by manual modi cations to the device are not subject to
warranty.
• During the operation the housing becomes hot). Allow the xture to cool approximately 20 minutes
prior to manipulate with it.
• Make sure that the available voltage is not higher than stated on the rear panel.
• WARNING! This unit does not contain an ON/OFF switch. Always disconnect power input cable to
completely remove power from unit when not in use or before cleaning or servicing the xture.
• Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and
the power-cord from time to time.
• Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle
the power-cord by the plug. Never pull out the plug by tugging the power cord.
• This device falls under protection class I. Therefore, it is essential to connect the yellow /green
conductor to earth.
• The electric connection, repairs and servicing must be carried out by a quali ed employee. Do not
connect this device to a dimmer pack.
• Do not switch the xture on and o in short intervals as this would reduce the lamp's life.
• During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
• Do not touch the device's housing bare hands during its operation (housing becomes hot)! For
replacement use lamps and fuses of same type and rating only.
CAUTION! EYE DAMAGES!
Avoid looking directly into the light source! (Mean especially for epileptics)!
User Manual | Q-P00712 by Triton Blue | For Professional use only, not for residential use
13.
Publicidad
