Publicidad
Idiomas disponibles
Idiomas disponibles
1.
One light ON: 30% remaining capacity.
2.
Two lights ON: 60% remaining capacity.
3.
All lights ON: 100% remaining capacity.
WARNING
instructions, read the operator's manual supplied with your charger and battery.
WARNING
accessories specifically recommended for this tool. Others may be hazardous.
INSTALLING OR REMOVING BATTERY PACK
A
B
TO REMOVE BATTERY PACK: Depress the battery release button (C) and pull
battery pack (B) out of tool (A). (see Fig. 2)
TO INSTALL BATTERY PACK: Push battery pack (B) onto tool until it locks in
place. (see Fig. 2)
INSTALLING THE CARRIAGE OR BARREL
Use only rods and carriages specifically designed for the Caulking Gun. Other rods and
carriages may cause damage to the tool. Place the carriage over the piston and rod.
Hold the carriage collar securely while screwing the carriage into the collar.
INSTALLING CAULK OR ADHESIVE TUBE
Always check tubes for punctures or damage before installing. Do not use a damaged
or frozen tube.
1. Cut nozzle of tube at an angle and size per manufacturer's recommendation to suit
the job (unless the nozzle is pre-cut). A smaller nozzle diameter requires more force
to push the caulk and reduces battery life.
2. Break the inner seal of the tube. If the inner seal is not broken, the caulk material
may be forced out the rear end of the tube and damage the tool.
1English1
Recharge only with the charger specified for the battery. For specific charging
Always remove battery pack before changing or removing accessories. Only use
OPERATION
English
Fig. 2
-8
C
Publicidad
