Descargar Imprimir esta página

EQUATION FSE40-23A Manual De Instrucciones página 62

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
EN
1.Assemble the base (4)
Insert the base screw (1) through the base washer (2), the weight (3), and the base (4) while ensuring that the
base washer, the weight and the base are correctly positioned.
2.Fix the stand (5) to the base (4)
Align and insert the stand (5) into the base (4), then tighten everything by turning the base screw (1)
clockwise.To adjust the stand height, loosen the fastening screw (6) and set the desired height, then tighten
the fastening screw once the desired height has been achieved.
3.Fix the engine unit (9) to the upper tube (7)
Position the engine unit (9) on the upper tube (7), then tighten the engine unit with the upper tube screw (20),
upper tube nut (21), engine screw A (18), and engine screw B (19) while ensuring that the screws and the nut
are correctly located.
4.Fix the rear guard (14) to the engine unit (9).
Position the rear guard (14) onto the engine unit (9) while ensuring that the four holes on the rear guard are
aligned with the four holes on the engine unit, and the rear guard handle must be turned upward. Then
tighten the rear guard with the four screws (15) and four washers.
5.Fix the blade assembly (16) to the engine shaft (12).
Unscrew the blade screw (13) from the blade assembly (16). Slide the blade assembly exactly onto the notch
of the engine shaft (12), and tighten the blade assembly with the blade screw while ensuring that the blade
screw is positioned onto the flat part of the engine shaft.
6.Fix the front guard (17) to the rear guard (14)
Position the front guard (17) over the rear guard (14) while ensuring that the small hole on the front guard edge
is aligned with the small hole at the bottom of the rear guard. Tighten the front guard fastenings, then further
fasten using the safety screw with nut (22) at the bottom of the guard.
USE
Speed adjustment
-
Turn the rotary switch (11) to select a desired fanning speed.
I
: Low speed
II
: Medium speed
III
: High speed
0
: Stop
Activate oscillation
Press down on the oscillation knob (10) to activate oscillation,
and pull up on it to deactivate.
62

Publicidad

loading

Este manual también es adecuado para:

Fse40-23a cyFse40-23a sa2024r08p08-02342024r08p08-02352024r08p08-0237