Publicidad
Idiomas disponibles
Idiomas disponibles
41
NOTES ON INSTALLATION
TURNTABLE ASSEMBLY
ePIace the turntable on a level surface,
Do not connect the mains lead or the connecting cords until
e Allow 10 cm (4 inches) clearance behind the unit so that the
after finishing the assembly.
cover can be opened,
Remove all packing material and clean the cabine\.
eAvoid placing the unit near electrical appliances (such as a
television, hair
dryer, or fluorescentlamp) which may cause
hum or noise,
eAvoid any vibration (such as from speakers, slamming of
doors, etc.).
e Keep the unit away from direct sunlight, extremes of tempera
ture, or excessive dust and moisture,
ADAPTATION TO THE LOCAL MAINS
SUPPLY
The PS-3300 comes in two types.
Type I operates only on 240 V ac",
Type If operates on either 110, 127, 220 or 240 V
ac~,
For the type 11, before connecting to the mains supply, check
th at the voltage selector located at the bottom of your set is
set to your local mains supply.
.
If necessary, turn the selector switch with a coin or something
similar, so that the arrow mark point the proper
voltage
marking.
110V
127V
nov
240V
•
A line frequency change is not necessary since your turntable
system is furnished with a dc servo controlled motor.
Warning to the customers in the United Kingdom
THIS APPARATUS MUST BE EARTHED TO YOUR 3-PIN PLUG IN
ACCORDANCE WITH FOLLOWING INSTRUCTIONS.
IMPORTANT:
The wires in this mains lead are coloured in
accordance with the following code:
Green-and-yellow:
Earth (safety earth)
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings identifying the
terminals in your plug proceed as follows :
The wire which is coloured green-and-yellow must be connected
to the terminal in the plug which is marked with the letter E
or by the safety earth symbol
;è:
or coloured green or green
and-yellow,
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
I
servo-control head
Do not touch the head
with fingers or tools
o
Place the Platter on the frame by holding it with the two
smaller holes.
e Do not touch the magnetic coating with your fingers or tools
to avoid scratching it and damaging the electron ic speed con trol
system,
~~~~~~2?7)L-magnetic
coating edge
of the Platter
@ Place the Rubber Mat on the Platter.
eNever connect the mains lead without the Platter installed.
Otherwise the motor will run at an uncontrolled speed.
e Be careful that no foreign objects lodge under the Platter.
e Do not attempt to rotate the Platter counterclockwise by hand.
e Save the packing box and materials for possible future use.
5
Publicidad
