Publicidad
Idiomas disponibles
Idiomas disponibles
Using the following procedure the settings held in the transmitter memory can be partially deleted (or
completely deleted resetting to the factory settings).
1.
With the transmitter turned off press the "
button
SETUP
Systems
Settings
▲
2.
Using the "
"and "
"Settings" and confirm with the "
SETTINGS
Keyguard
Language
Backlight
Reset
▲
3.
Using the "
"and "
"Reset" and confirm with the "
RESET
Reset Setting
Reset All
If intermediate stopping points are set in systems controlled by Ref. 5449 transmitter, when a brief impulse is
sent the systems activated will reach the first stopping point in sequence.
To open or close completely the command must be held down for 4" (the colour of the "send R.F. command"
symbol changes from blue to white).
The transmitter Ref. 5449 takes three 1.5V AAA batteries (or 1.2V AAA rechargeable). To replace the battery
follow the directions in attached "A".
Please note that the old battery cannot be disposed of with non-differentiated urban waste but must be
collected separately in accordance with the regulations set down by the local authorities.
SIGNALS
Thermoswitch
Transmission frequency: 868 MHz – 915 MHz
M2net two-way communication protocol
OLED (Organic Light Emitting Diode - 160x128 - 262.144 colour) graphic display
Possibility of controlling up to 100 systems individually
Possibility of controlling up to 25 systems groups (of 20 systems each)
Built-in antenna
USB connection
Energy saving with automatic shutdown
Battery: 3 x 1,5V AAA (or 1,2V AAA rechargeable)
Dimensions (mm) : 56 x 190 x 20
Reset
●
"
▼
" buttons select
■
" button
▼
" buttons select
■
" button
Intermediate stopping points
Changing the battery
Signals
POSSIBLE CAUSE
The motor has reached the
heat protection threshold
Technical Characteristics
4.
Using the "
"Reset Setting" and confirm with the "
data for the systems and groups will remain
unchanged)
4.
Using the "
"Reset All" and confirm with the "
systems will be removed and the transmitter will be
reset to the factory settings)
CONFIRM
Confirm?
5.
Confirm again with the "
the "
" symbol and confirm with the "
return to the previous display
Let the motor cool for a few minutes and
9
Z249 rB
▲
▼
"and "
" buttons select
■
" button (all the
▲
▼
"and "
" buttons select
■
" button (all the
■
" button or select
■
" button to
REMEDY
try again.
19
Publicidad
