Publicidad
Idiomas disponibles
Idiomas disponibles
EN Safety FR Sécurité PL
RO
EN
Safety
•
For domestic use only.
CAUTION: DO NOT OVERTIGHTEN THE
FIXINGS OTHERWISE IT MAY DAMAGE
THE PRODUCT.
CAUTION: NOT SUITABLE FOR
USE IN CONJUNCTION WITH
INSTANTANEOUS WATER HEATERS
(E.G. AN INSTANTANEOUS WATER
HEATER WITHOUT MODULATION AND
WITHOUT WATER TANK).
•
Care should be taken when drilling into walls to
avoid any hidden pipes or wires.
•
When drilling through ceramic tiles use a
specialist drill bit.
•
Where possible drill between tiles in the grout.
CAUTION: ALWAYS ENSURE THE
PRODUCT IS SECURELY INSTALLED
BEFORE USE.
•
When the installation is complete, turn the water
supply on and check for leaks on connection
points.
•
Failure to follow these instructions may result
in personal injury, damage to the product and
property damage.
•
Prevention of frost damage.
•
When the domestic water system is drained,
thermostat mixers must be drained separately,
and cold water connections. For this purpose,
the mixer must be removed from the wall.
•
Always be aware of the danger of scalding
from hot water. Ensure users are aware of
the maximum temperature especially if the
temperature stop has been adjusted.
•
Never twist or kink the hose or otherwise restrict
Getting started
•
Check to make sure you have all of the parts
listed.
•
When you are ready to start, make sure you
have the right tools to hand, plenty of space and
a dry area for assembly.
•
Ensure the mounting surface is sound, clean,
dry and level before this full system is installed.
5059340578057_MNL_IN_V03.indb 3
ES Seguridad PT Segurança TR Emniyet
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3
Please note: The wall plugs included with
this product are suitable for solid walls only.
Plasterboard or stud walls may require
correct for the wall type.)
before connecting mixing valves to ensure no
pipe/plumbing debris enters the mixing valves.
TURN OFF WATER MAINS SUPPLY. The
mains stopcock is usually situated where the
supply enters the building.
It is also recommended that the water heating
arrangements are turned off.
Isolate the hot and cold water supply.
This product has been tested to and meets
the requirements of the Water Supply (Water
Fittings) Regulations. (UK only).
This product must be connected to a water
supply in accordance with the Water Supply
(Water Fittings) Regulations and UK Building
Regulations. If you are in any doubt about these
local Water Company or the Water Regulations
Advisory Scheme (WRAS). (UK only).
Always maintain a 10ºC difference between the
hot system temperature and the maximum hot
temperature setting of the valve.
Hot and Cold maximum pressure differential
should be no more than 2 bars. If this limit
(not supplied).
Operating pressures on hot and cold lines
should be kept as even as possible in order to
When water pressure is higher than 5 bar a
pressure reducing valve (not supplied) must be
the wall unions, if available, to reduce water
consumption on high pressure systems.
Each shower valve is supplied with integral non
return valves in the hot and cold inlet tail pieces
the water supplies.
6/7/22 6:06 PM
Publicidad
