Led Indication Front Panel; Configuration Example - Safeline SL6+ Guía Rápida De Inicio

LED indication
front panel
LED 1 indicates the power supply status
Fig 3.1 -
Continuous green
Flashing red (400/400 ms)
Continuous red
LED 2 indicates active alarm and battery condition
Fig 3.1 -
Light off
Rapidly flashing yellow (200/200 ms)
Flashing red (400/400 ms)
Continuous red
LED 3 indicates the phone line's status
Fig 3.1 -
Flashing green (100/100 ms)
Flashing green (400/400 ms)
Slowly flashing green (200/4600 ms)
Continuous green
Flashing yellow (100/100 ms)
Flashing red (400/400 ms)
Continuous red
Reset button
Fig 3.1 -
Press for 3 sec
Press 3 times
Press once
Press 5 sec - release
p. 16
Configuration
example
If at any time you need to start
over, use the factory reset
command *99*1#.
Please refer to the full
configuration setup in the
"Parameter list" as these are
merely examples.
p.28
Mains power supply OK.
Battery operated, with power to the emergency light.
Battery operated, no power to the emergency light.
No active alarm/battery OK.
Active alarm not reset.
Battery check in progress.
Battery test failure/no battery connected.
Fire mode activated.
Call connection in progress.
Telephone line connected. / GSM network OK.
Call connected.
Incoming call.
No telephone line connected. / Searching for GSM network.
No SIM card (when using GSM).
Show GSM signal strength (see table below).
Start a self test (battery + bus initialization).
Resets an active alarm. Aborts calls in progress.
SL6+ turns off. NOTE: refers to battery powered only
Storing of two different telephone numbers, one to be answered by
P100 code and the other one with voice.
1. Start configuration:
0 0
2.
1st phone number:
* 1 1 * 1 2 3 4 5 6 7 8 #
3. 2nd phone number:
* 1 2 * 2 3 4 5 6 7 8 9 #
4. Call type 1st number:
* 2 1 * 0 #
5. Call type 2st number:
* 2 2 * 1 #
6.
Alarm button delay:
* 8 7 * 0 3 #
7. End configuration:
* 0 0 * #
30
- Example: Answered with P100 code.
- Example: Answered as voice call.
- Example: 3 seconds delay.
English