Montaje del controlador
Se recomienda retirar la puerta y el panel frontal antes de
montar el controlador. Si bien estos pasos no son absolutamente
necesarios, facilitan la instalación.
A
Si fuese necesario, abra el cierre de la puerta con la llave
que se proporciona. Abra la puerta del gabinete y gírela
hacia la izquierda.
B
Retire la puerta de las bisagras.
C
Abra el panel frontal agarrando el apoyo para el dedo en
forma de medialuna que está en la parte superior derecha
del gabinete. Abra el panel frontal hacia la izquierda.
D
Desconecte el cable plano del panel tirando suavemente
del conector hacia arriba y separándolo del enchufe. Evite
tirar directamente del cable plano.
E
Deslice los pasadores de las bisagras del panel frontal fuera
de los orificios del gabinete. Retire primero la parte inferior
del panel.
F
PRECAUCIÓN: Al volver a ensamblar el conector,
observe la orientación modificada de éste. Si se
conecta correctamente, la línea roja del cable estará
en el lado superior.
Sistema de control modular inteligente ESP-SMT
57
This device complies with Part 15 of the FCC Rules.
LAWN SPRINKLER CONTROL
Operation is subjected to the following two conditions:
-DOMESTIC-
(1)
This device may not cause harmful interference and
INPUT: 120 VAC, 0.3 AMPS, 60Hz
(2)
This device must accept any interference received,
OUTPUT: 25.5 VAC, 1.0 AMPS, 60Hz
including interference that may cause undesired operation.
This class B digital apparatus meets all requirements of the
Canadian Interference Causing Equipment Regulations.
Cet appariel Numérique de la classe B respecte toutes les
exigences du Règlement sur le matériel brouilleur du Canada.
SMX SENSOR
WARNING
RISK OF FIRE, EXPLOSION AND ELECTRICAL SHOCK.
THIS CONTROLLER USES A NON-REPLACEABLE LITHIUM
BATTERY. DISPOSE OF ALL ELECTRONIC PRODUCTS IN
ACCORDANCE WITH LOCAL LAWS AND FEDERAL REGULATIONS.
RESET
IF DISPLAY IS SCRAMBLED
OR BLANK, PUSH THE
RESET BUTTON
This device complies with Part 15 of the FCC Rules.
LAWN SPRINKLER CONTROL
Operation is subjected to the following two conditions:
-DOMESTIC-
(1)
This device may not cause harmful interference and
INPUT: 120 VAC, 0.3 AMPS, 60Hz
(2)
This device must accept any interference received,
OUTPUT: 25.5 VAC, 1.0 AMPS, 60Hz
including interference that may cause undesired operation.
This class B digital apparatus meets all requirements of the
Canadian Interference Causing Equipment Regulations.
Cet appariel Numérique de la classe B respecte toutes les
exigences du Règlement sur le matériel brouilleur du Canada.
SMX SENSOR
WARNING
RISK OF FIRE, EXPLOSION AND ELECTRICAL SHOCK.
THIS CONTROLLER USES A NON-REPLACEABLE LITHIUM
BATTERY. DISPOSE OF ALL ELECTRONIC PRODUCTS IN
ACCESSORY
ACCORDANCE WITH LOCAL LAWS AND FEDERAL REGULATIONS.
RESET
IF DISPLAY IS SCRAMBLED
OR BLANK, PUSH THE
RESET BUTTON
AB
C
ALARM
AUTO
SET DATE
OFF
& TIME
CONFIGURE
MANUAL
CONTROLLER
WATERING
RESTORE
INPUT ZONE
SETTINGS
INFORMATION
SYSTEM
SPECIAL
ENGLISH
ENGLISH
REVIEW
FEATURES
ESPAÑOL
ESPAÑOL
FINE-TUNE
WATERING
SMART MODULAR CONTROLLER
C
ACCESSORY
D
E