Ups Configuration - Riello Dialog Dual Serie Manual De Usuario

UPS C
ONFIGURATION
The following table illustrates all the possible configurations that users have at their disposal to best adapt
the UPS to their needs.
LEGEND:
=
=
FUNCTION
Selects the nominal
Output frequency
output frequency
Selects the nominal
Output voltage
Selects one of the 4
Operating mode different modes of
automatic switching
Switch-on delay
on again after the
Automatic UPS
switch-off when in
Switch-off due to
battery-powered
minimum load
operation, if the load
Back-up Maximum battery
limitation
Estimated remaining
End of discharge back-up time for the
early warning end of discharge early
Indicates that the configuration can be modified, both via the configuration
software supplied and also by means of action on the display panel.
Indicates that the configuration can be modified only through the configuration
software supplied.
DESCRIPTION PREDEFINED
Auto
230V
output voltage
ON LINE
operation
Delay time for
5 sec.
mains returns
Disabled
is less than 5%
Disabled
operation time
3 min.
warning
POSSIBLE CONFIGURATIONS
• 50 Hz
• 60 Hz
• Auto: automatic self-teaching of the
input frequency
• 220V
• 230V
• 240V
• 220 ÷ 240 in steps of 1V
(only through the software)
• ON LINE
• ECO
• SMART ACTIVE
• STAND-BY OFF
• Disabled
• 1 ÷ 255 in steps of 1 sec.
• Enabled
• Disabled
• Disabled (full battery discharge)
• 1 ÷ 65000 in steps of 1 sec.
1 ÷ 255 in steps of 1 min.
U
SE
MODE
55