Crosley YTD74 Manual Del Propietário página 10

Getting started
Extended Tumble
H
(on some models)
Use this option to minimize the wrinkles in clothes . It provides 1 hour of no-heat tumbling after the clothes are dry . If
you are using the cycle Signal Adjust and you select the Extended Tumble option, a signal will sound at the end of
the drying time and several times during the Extended Tumble cycle . This will remind you that it is time to remove the
clothes . NOTE: On models with an Extended Tumble knob, it provides approximately 15 minutes of no-heat tumbling
after the clothes are dry .
Damp Alert
(on some models)
This option causes the dryer to beep when clothes have dried to a damp level . Remove items that you wish to hang
dry . The Damp Alert will only beep when this option is selected (but the dry cycle will keep running) . Removing clothes
and hanging them when they are damp, can reduce the need to iron some items . The light beside the button will be
lit when Damp Alert is on .
Drum Light
(on some models)
The drum light will turn on if the Damp Alert button is pressed for 3 seconds or the door is opened . It will turn
off when the door is shut, the Damp Alert button is pressed again for 3 seconds or after 5 minutes if the door is
left open .
Delay Dry
Press the Delay Dry button to set the delay start time in 1 hour increments up to 24 hours, and then back to clear (0
hours) . After selecting the delay start time, press Start and the delay time will count down the time remaining until the
cycle starts . NOTE: To set the amount of delay time faster, you can press and hold the Delay Dry button .
Signal Adjust
(on some models)
Use the Signal Adjust option to change the volume of the button presses (on some models) and the end of cycle
signal . Press the button or turn the knob (depending on model) until you reach the desired volume or off . The clothes
should be removed when the end of cycle signal goes off so wrinkles do not set in .
NOTE:
• Remove garments promptly at the sound of signal . Place clothes on hangers so wrinkles will not set in .
• Use the Signal Adjust especially when drying fabrics like polyester, knits and permanent press . These fabrics
should be removed so wrinkles will not set in .
My Cycle
I (on some models)
As the cycle selector knob is turned, the Time (timed dry), Level (dryness level) and Temp (temperature)
settings change to automatic pre-set default settings . If you desire a different setting, press the appropriate button(s) .
Then press and hold the My Cycle button for 3 seconds and the dryer will "remember" these settings for that Knob
Selection . In the future, when you turn the selector knob to that cycle, your settings will be automatically recalled .
NOTE: Signal volume cannot be set for My Cycle .
10
49-3000224 Rev 3