Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the GigBAR MOVE + ILS.
■
The luminaire is intended for professional use only.
■
The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than
20.7 ft (6.3 m) is not expected.
■
If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord
exclusively available from the manufacturer or its service agent.
■
The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or
a similar qualified person.
■
ALWAYS:
♦
Connect to a grounded circuit.
♦
Connect to operating voltages as specified on the product's spec sticker.
♦
Disconnect from power before replacing the fuse.
♦
Disconnect from its power source during periods of inactivity.
♦
Use a safety cable when suspending overhead.
♦
Heed all restrictions and warnings on the spec sticker.
♦
Mount in a location with at least 20 in (50 cm) of ventilation.
♦
Replace the fuse with the same type and rating.
■
In the event of a serious operating problem, stop using immediately.
■
DO NOT:
♦
Open this product or attempt any repairs. It contains no user-serviceable parts.
♦
Look at the light source when the product is on.
♦
Use if the power cord is crimped or damaged.
♦
Disconnect by pulling on the power cord.
♦
Allow flammable materials close to the product when it is operating.
♦
Touch the housing when it is on.
♦
Block any ventilation holes/slots in the housing.
♦
Connect to a dimmer or rheostat.
♦
Carry the product by its power cord.
♦
Operate in temperatures higher than 104°F (40°C).
♦
Expose to environments that exceed the Ingress Protection (IP) rating.
♦
Expose to rain or moisture.
♦
Use outdoors.
♦
Submerge.
♦
Leave outdoors for extended periods of time.
♦
Expose to corrosive environmental conditions such as temperature, humidity, salinity, pressure, radiation,
or shock.
♦
Set this product on a flammable surface.
1
QUICK REFERENCE GUIDE
GigBAR MOVE + ILS QRG Rev. 2
Publicidad
