EarthQuaker Devices Afterneath Manual De Instrucciones página 5

TAILS/NO TAILS SWITCHING
The Afterneath is factory set in "tails mode." This means
that the wet signal will naturally decay and slowly fade to
silence after the effect is switched off.
To deactivate this feature:
1. Unplug the power cable from the power jack.
2. Hold down the footswitch and insert the power cable.
3. The LED will flash 3 times. You can now release the
footswitch.
Follow the same steps to reactive tails mode.
POWER REQUIREMENTS
Current Draw .................. 100 mA
This device takes a standard 9 volt DC power supply with
a 2.1mm negative center barrel. We recommend using
a pedal-specific, transformer-isolated, wall-wart power
supply or a power supply with multiple isolated-outputs.
Pedals will make extra noise if there is ripple or unclean
power. Switching-type power supplies, daisy chains and
non-pedal specific power supplies do not always filter
dirty power and may result in unwanted noise.
DO NOT RUN AT HIGHER VOLTAGES!
6
TECH SPECS
Input Impedance ................ 1 MΩ
Output Impedance .............500 Ω
WARRANTY
This device has a limited lifetime warranty. If it breaks,
we will fix it. Should you encounter any issues, please
visit www.earthquakerdevices.com/support.