SLV SITRA SPIKE 230374 Instrucciones De Montaje página 3

INSTALLATION MANUAL for OUTDOOR LIGHT
SITRA SPIKE 230374/75
The installation may only be carried out by an approved
electrician, who is familiar with valid directives and
regulations!
Explanation of the safety warnings:
immediate dangerous situation leading to death or
DANGER:
severe injuries when not avoided.
possible dangerous situation leading to death or
WARNING:
severe injuries when not avoided.
possible dangerous situation leading to injuries or
CAUTION:
material damage when not avoided.
In case of disregarding this manual the warranty will be void!
Pay also absolute attention the NOTES ON SAFETY on the
backside!
1. INSTALL AS DIRECTED
This product serves exclusively lighting purposes and may:
only be connected to a voltage of 230V ~50Hz.
only be operated when firmly mounted.
not be exposed to strong mechanical loads or to strong
contamination.
only be installed and operated after a condition inspection if the
product is dirty or has been moistened through storage.
not be modified or converted.
2. UNPACKING
Carefully take the product out of the packaging removing any
transport safeguards.
Before disposal of the packaging material make sure that all
components of the product are removed.
WARNING
Inspect the product for loose parts inside the housing. When there are
loose parts inside the housing and these are not explicitly described the
product may not be installed or operated.
Parts that may be touched are maybe voltage-carrying. Danger of
electric shock!
3. INSTALLATION
WARNING
Switch off the mains or respectively the connection lead before doing
.
any works
There exists mortal danger from an electric shock.
Use only accessory parts, which are supplied with the product or are
described as accessories!
Otherwise the product or the whole installation may not be secure.
Danger for life or danger of fire may exist!
Installation place
The product is suited for installation on the ground.
Choose a place where the installation is not a danger (e.g. stumbling,
knocking).
Separate Installation Steps
Inserting the light source: Loosen the screws on the lamp head and
remove the glass cover. Insert the bulb with a quarter-turn to the right.
Attach the glass cover again. Tighten the screws in a cross-wise order,
to achieve an even pressure on the gasket. Note the proper fit for the
gasket.
Screw the spike on the fitting. Insert the spike into the soil. The earth
spike must be anchored in the ground, so that the product cannot fall
down. The ground may not be permanently wet.
To adjust the lamp head loosen the screw (1). Adjust the lamp head in
the desired position and fix it again with the screw.
Electrical Connection
Connect the plug with a suitable outdoor socket (i.e. SLV art-no.
227000).
Ensure that the light fixture holds securely!
The product is now ready for operation.
4. FIRST OPERATION
On the first operation check if the product functions properly!
DANGER
In case of a malfunction you may NOT touch the product or operate it
further. Disconnect the product from the power supply by an external
switch or by the fuse.
If touched or further operated there is danger from electric shock,
burning, or fire.
A malfunction exists when:
visible damages appear.
the product does not work properly (e.g. flickering).
smoke, steam or crackling sounds appear.
smell of burning is recognisable.
an overheating is recognisable (e.g. by discolouration of adjacent
surfaces).
Operate the product only after maintenance and examination by an
approved electrician!
Notice for the electrician:
It is your responsibility to hand out the user manual on the reverse
side to the end user.