Publicidad
Idiomas disponibles
Idiomas disponibles
• Electrical connection
• Do not use an extension cord or double adapter.
• If the supply cord is damaged, it must be replaced by a qualified person in order to avoid a hazard.
• If the machine will not be used for an extended time, unplug it and shut off the water supply.
• Connect the machine to a grounded outlet in accordance with current wiring regulations.
• The appliance must be positioned so that the plug is easily accessible.
• Connecting water supply hose
Hot
Cold
water
tap
Sealing
• Water supply pressure must be between
14.5 and 116 PSI (100N800 kPa).
• Do not crossthread when connecting inlet hose to
the valve.
• If the water supply pressure is more than 116 PSI,
a pressure reducing device should be installed.
• Two Sealing washers are supplied with the water
inlet hoses to prevent water leaks.
• Check for leakage of washing machine connections
by turning the tap completely on.
• Periodically check the condition of the hose and
replace the hose if necessary.
• Make sure that there is no kink in the hose and that
it is not crushed.
• Be sure that the two water input ports are connected
to the correct water faucets. The connector for hot
water is colored red.
NOTE:
Washing
Machine
is to be connected
to the water
mains
using new hoses.
Old hoses should not be used.
Repairs
to the washing
machine
must only be carried
out by qualified
personnel.
Repairs carried
out by
inexperienced
persons
may cause injury or serious
malfunctioning.
Contact
your local service
center.
Do not install yore" washing
machine
in a room where
temperatures
below freezing
may occur.
Frozen
hoses may bm'st
under pressure.
The reliability
of the electronic
control
unit may be impaired
at temperatures
below
the freezing
point.
If the appliance
is delivered
in the winter
months
and temperatures
are below freezing,
store the washing
machine
at room temperatm'e
for a few hours before
putting
it into operation.
7
Publicidad
